Luminary Micro在Stellaris系列微控制器的部分產品中提供了模數轉換器（ADC）模塊。ADC的硬件分辨率為10位，但由于噪音和其它使精度變小的因素的影響，實際的精度小于10位。本應用文檔提供了一個基于軟件的過采樣技術，從而使轉換結果的有效位數（ENOB）得到了改善。文檔中描述了對輸入信號執行過采樣的方法，以及在精度和整個系統性能上的影響。
上傳時間： 2014-05-07
上傳用戶：drink！
Luminary Micro provides an analog-to-digital converter (ADC) module on some members of theStellaris microcontroller family. The hardware resolution of the ADC is 10 bits; however, due to noiseand other accuracy-diminishing factors, the true accuracy is less than 10 bits. This application noteprovides a software-based oversampling technique, resulting in an improved Effective Number OfBits (ENOB) in the conversion result. This document describes methods of oversampling an inputsignal, and the impact on precision and overall system performance.
標簽： Oversampling Techniques ADC fo
上傳時間： 2013-12-17
上傳用戶：zhyiroy
Luminary Micro Stellaris™ microcontrollers that are equipped with an analog-to-digital converter(ADC), use an innovative sequence-based sampling architecture designed to be extremely flexible,yet easy to use. This application note describes the sampling architecture of the ADC. Sinceprogrammers can configure Stellaris microcontrollers either through the powerful StellarisFamilyDriver Library or through direct writes to the device's control registers, this application note describesboth methods. The information presented in this document is intended to complement the ADCchapter of the device datasheet, and assumes the reader has a basic understanding of howADCsfunction.
標簽： Microcontr Stellaris Using the
上傳時間： 2013-10-14
上傳用戶：blans
The MAX3243E device consists of three line drivers, five line receivers, and a dual charge-pump circuit with±15-kV ESD (HBM and IEC61000-4-2, Air-Gap Discharge) and ±8-kV ESD (IEC61000-4-2, Contact Discharge)protection on serial-port connection pins. The device meets the requirements of TIA/EIA-232-F and provides theelectrical interface between an asynchronous communication controller and the serial-port connector. Thiscombination of drivers and receivers matches that needed for the typical serial port used in an IBM PC/AT, orcompatible. The charge pump and four small external capacitors allow operation from a single 3-V to 5.5-Vsupply. In addition, the device includes an always-active noninverting output (ROUT2B), which allowsapplications using the ring indicator to transmit data while the device is powered down. The device operates atdata signaling rates up to 250 kbit/s and a maximum of 30-V/ms driver output slew rate.
標簽： MULTICHANNEL 5.5 TO RS
上傳時間： 2013-10-19
上傳用戶：ddddddd
本文依據集成電路設計方法學，探討了一種基于標準Intel 8086 微處理器的單芯片計算機平臺的架構。研究了其與SDRAM，8255 并行接口等外圍IP 的集成，并在對AMBA協議和8086 CPU分析的基礎上，采用遵從AMBA傳輸協議的系統總線代替傳統的8086 CPU三總線結構，搭建了基于8086 IP 軟核的單芯片計算機系統，并實現了FPGA 功能演示。關鍵詞：微處理器； SoC；單芯片計算機；AMBA 協議 Design of 8086 CPU Based Computer-on-a-chip System（School of Electrical Engineering and Automation, Heifei University of Technology, Hefei, 230009,China）Abstract: According to the IC design methodology, this paper discusses the design of one kind of Computer-on-a-chip system architecture, which is based on the standard Intel8086 microprocessor,investigates how to integrate the 8086 CPU and peripheral IP such as, SDRAM controller, 8255 PPI etc. Based on the analysis of the standard Intel8086 microprocessor and AMBA Specification,the Computer-on-a-chip system based on 8086 CPU which uses AMBA bus instead of traditional three-bus structure of 8086 CPU is constructed, and the FPGA hardware emulation is fulfilled.Key words: Microprocessor; SoC; Computer-on-a-chip; AMBA Specification
上傳時間： 2013-12-27
上傳用戶：kernor
基于單片機的步進電機開環控制系統:通過ATMEL89C51單片機對步進電機進行控制,主要介紹了步進電機控制器、驅動電路和LED顯示電路的設計,實現了步進電機的開環控制。在步進電機控制器的設計中,重點闡述了脈沖產生電路以及對速度的控制。該系統具有成本低、控制方便的特點。關鍵詞: 單片機; 步進電機; 開環控制 Abstract: The design using ATMEL89C51 single chip to control the step2motor with its controller, driving circuit and LED disp lay circuit to realize step motor open2loop controlwere introduced. For the controller in this design,the circuit to p roduce pulse and the speed controlwere expatiated emphatically. This system possesses features of lower cost, easier control.Key words: single ch ip; step2motor; open2loop con trol
上傳時間： 2013-10-13
上傳用戶：cicizoe
基于單片機的除塵控制器的設計:介紹通用控制儀的硬件組成和軟件設計,闡述了系統的性能指標和功能特點。該產品功能完善,可靠性高,具有很好的應用前景。關鍵詞: 除塵器;通用控制儀;單片機;系統設計 Abstract: The hardware structure and the software design are introduced in this paper, and the performance index and the features of the system are expounded. It has comp rehensive functions, high reliability and good app lication.Key words: dust catcher; universal controller; microcontroller; system design
上傳時間： 2013-11-16
上傳用戶：ming52900
SPCE061A采用的內核 SPCE061A采用的內核（CPU）為μ‘nSP。 μ‘nSP（讀做micro-n-S-P）是凌陽科技推出的16位微處理器，它的突出特點是較高的處理速度，這就使其有能力進行復雜的數字信號處理（DSP，Digital Signal Processing）。 μ‘nSP內核由凌陽自主開發，因而也具備它自己的指令系統。 指令系統.61 3.1 指令系統的概述及符號約定.61 3.2 數據傳送指令62 3.3 算術運算..66 3.3.1 加法運算..67 3.3.2 減法運算..68 3.3.3 帶進位的加減運算.70 3.3.4 取補運算..70 3.3.5 SPCE061A的乘法指令.71 3.3.6 SPCE061A的n項內積運算指令.71 3.3.7 比較運算(影響標志位N,Z,S,C)..73 3.4 SPCE061A的邏輯運算.74 3.4.1 邏輯與..74 3.4.2 邏輯或..75 3.4.3 邏輯異或..76 3.4.4 測試（TEST）.78 3.4.5 SPCE061A的移位操作.80 3.5 SPCE061A的控制轉移類指令..83 3.6 偽指令86 3.6.1 偽指令的語法格式及特點..87 3.6.2 偽指令符號約定..87 3.6.3 標準偽指令.87 3.6.4 宏定義與調用98 3.6.5 段的定義與調用101 3.6.6 結構的定義與調用..102 3.6.7 過程的定義與調用..106 3.6.8 偽指令的應用舉例..106
上傳時間： 2013-10-31
上傳用戶：xuanchangri
82C59A-2是為簡化微處理機系統中斷接口而實現的LSI外圍芯片。也叫做PIC（Programmable Interrupt Controller）。是高性能高速度芯片。在多級優先級中斷系統內82C59A-1402已經把CPU從對任務的輪詢中解救出來。PCI可由軟件進行控制，使用于各種不同的環境，聯級可接受8~64個中斷輸入。 管腳與NMOS8259A-2兼容單片8級優先級，級聯可擴64級多種可編程中斷方式各自專用的請求屏蔽能力與Intel系列機兼容全部采用靜態設計低功耗5V的電源供電。
上傳時間： 2013-10-30
上傳用戶：zhliu007
基于單片機控制的二氧化碳濃度測試計:基于CDM4161二氧化碳氣體濃度測試模塊以及ATtiny26單片機,提出了一種二氧化碳濃度測試計的設計方案。該方案具有硬件電路簡單、成本低、可靠性高、測量準確等優點，具有較高的實用價值。 Abstract: Abstract：A desigh scheme of CO2 concentration meter based on CDM4161carbon dioxide concentration test module and ATtiny26micro-Controller is presented in this paper.The design scheme features simple hardware circuit,low-cost,high reli-ability，accurate measurement and it has a high practical value.
上傳時間： 2013-11-14
上傳用戶：zjwangyichao
