Smart temperature sensor and application of the principle of DS18B20
標簽： temperature application principle sensor
上傳時間： 2013-12-15
上傳用戶：qweqweqwe
The PCMCIA Solution PCMCIA System Architecture
標簽： PCMCIA Architecture Solution System
上傳時間： 2013-11-30
上傳用戶：eclipse
Sensing and planning are at the core of robot motion. Traditionally, mobile robots have been used for performing various tasks with a general-purpose processor on-board. This book grew out of our research enquiry into alternate architectures for sensor-based robot motion. It describes our research starting early 2002 with the objectives of obtaining a time, space and energy-efficient solution for processing sensor data for various robotic tasks. New algorithms and architectures have been developed for exploration and other aspects of robot motion. The research has also resulted in design and fabrication of an FPGA-based mobile robot equipped with ultrasonic sensors. Numerous experiments with the FPGA-based mobile robot have also been performed and they confirm the efficacy of the alternate architecture.
標簽： Traditionally planning Sensing motion
上傳時間： 2013-12-20
上傳用戶：古谷仁美
Advanced firmware uploader s main body source code. For sti5518
標簽： Advanced firmware uploader source
上傳時間： 2013-12-14
上傳用戶：zaizaibang
MIPS32™ Architecture For Programmers
標簽： Architecture Programmers MIPS 8482
上傳時間： 2017-06-14
上傳用戶：zyt
ATutorial: Architecture of FPGAs and CPLDs
標簽： Architecture ATutorial FPGAs CPLDs
上傳時間： 2017-06-17
上傳用戶：變形金剛
turbity measurement using rgb sensor
標簽： measurement turbity sensor using
上傳時間： 2017-06-17
上傳用戶：stvnash
DSP Architecture with Jumping-Floating-Point Number System
標簽： Jumping-Floating-Point Architecture Number System
上傳時間： 2017-06-17
上傳用戶：璇珠官人
This application report discusses the design of non-invasive optical plethysmography also called as pulsoximeter using the MSP430FG437 Microcontroller (MCU). The pulsoximeter consists of a peripheral probe combined with the MCU displaying the oxygen saturation and pulse rate on a LCD glass. The same sensor is used for both heart-rate detection and pulsoximetering in this application. The probe is placed on a peripheral point of the body such as a finger tip, ear lobe or the nose. The probe includes two light emitting diodes (LEDs), one in the visible red spectrum (660nm) and the other in the infrared spectrum (940nm). The percentage of oxygen in the body is worked by measuring the intensity from each frequency of light after it transmits through the body and then calculating the ratio between these two intensities.
標簽： plethysmography non-invasive application discusses
上傳時間： 2014-01-17
上傳用戶：天誠24
The objective is to set up SPI communication between VTI Technologies digital pressure sensor component and an MCU of an application device ATMEGA16L. In this code example: ?The MCU is configured ?SCP1000-D01 is initialized and configured ?The high resolution measurement mode is activated ?Temperature and pressure information is read always when the DRDY pin is in high state Please refer to the document "SCP1000 Product Family Specification 8260800" for further information on SCP1000 register addressing and SPI communication. This document applies to the SCP1000-D01.
標簽： communication Technologies objective pressure
上傳時間： 2017-06-17
上傳用戶：youmo81
蟲蟲下載站版權(quán)所有 京ICP備2021023401號-1
