基于HT46R46E/HT46C46E經濟A/D型八位單片機 HT46R46E/HT46C46E 是8 位高性能精簡指令集單片機，專門為需要A/D 轉換的產品而設計，例如傳感器信號輸入。掩膜版本HT46C46E 與OTP 版本HT46R46E 引腳和功能完全相同。在HT46R46E/HT46C46E 封裝片里包含兩顆芯片：一顆是HT46R46E/HT46C46E 單片機，另一顆是作為通用數據存儲器的128×8 位的EEPROM。這兩顆芯片邦定在一起封裝為HT46R46E/HT46C46E。
上傳時間： 2013-10-31
上傳用戶：fdfadfs
HT45R35VC/R-F型八位OTP單片機 HT45R35V 是一款C/R-F 型具有8 位高性能精簡指令集的單片機，專門為需要VFD 功能的產品而設計。 秉承HOLTEK MCU 一般特性，該單片機帶有暫停和喚醒功能，振蕩器選項等等，這些都保證使用者的應用只需極少的外部元器件便可實現。這款單片機專門為直接與VFD 面板相連的VFD 應用而設計。集成C/R-F 功能，外加功耗低、性能良好、I/O 使用靈活、成本低等優勢，使這款單片機可以廣泛應用于VFD 相關產品中，例如家電定時產品，各種消費產品，子系統控制器，其他家電應用等方面。
上傳時間： 2013-11-07
上傳用戶：semi1981
This application report discusses the design of non-invasive optical plethysmographyalso called as pulsoximeter using the MSP430FG437 Microcontroller (MCU). Thepulsoximeter consists of a peripheral probe combined with the MCU displaying theoxygen saturation and pulse rate on a LCD glass. The same sensor is used for bothheart-rate detection and pulsoximetering in this application. The probe is placed on aperipheral point of the body such as a finger tip, ear lobe or the nose. The probeincludes two light emitting diodes (LEDs), one in the visible red spectrum (660nm) andthe other in the infrared spectrum (940nm). The percentage of oxygen in the body isworked by measuring the intensity from each frequency of light after it transmitsthrough the body and then calculating the ratio between these two intensities.
標簽： Pulsoximeter Single-Chip Des
上傳時間： 2013-10-27
上傳用戶：黑漆漆
DAC0832是一個8位D/A轉換器芯片，單電源供電，從+5V～+15V均可正常工作，基準電壓的范圍為±10V，電流建立時間為1μs，CMOS工藝，低功耗20mW。其內部結構如圖9.1所示，它由1個8位輸入寄存器、1個8位DAC寄存器和1個8位D/A轉換器組成和引腳排列如圖1所示。 • DAC0832工作方式• ADC0809工作方式要求掌握：• MCS-51單片機與D/A轉換器的接口連接• MCS-51單片機與A/D轉換器的接口連接• 初始化編程及應用了解：• 典型D/A轉換器芯片DAC0832的管腳功能• 典型A/D轉換器芯片ADC0809的管腳功能
上傳時間： 2014-01-14
上傳用戶：zl520l
ADC0809是帶有8位A/D轉換器、8路多路開關以及微處理機兼容的控制邏輯的CMOS組件。它是逐次逼近式A/D轉換器，可以和單片機直接接口。 adc0809 datasheet
上傳時間： 2013-10-11
上傳用戶：kz_zank
This application note describes how to decode standard DTMF tones using the minimum number of external discrete components and a PIC. The two examples use a PIC which has an 8 bit timer and either a comparator or an ADC, although it can be modified for use on a PIC which has only digital I/O. The Appendices have example code for the 16C662 (with comparator) and 16F877 (using the ADC). As the majority of the Digital Signal Processing is done in software, little is required in the way of external signal conditioning. Software techniques are used to model the individual elements of a DTMF Decoder IC.
上傳時間： 2013-11-21
上傳用戶：zhaoke2005
The PCA9540B is a 1-of-2 bidirectional translating multiplexer, controlled via the I2C-bus.The SCL/SDA upstream pair fans out to two SCx/SDx downstream pairs, or channels.Only one SCx/SDx channel is selected at a time, determined by the contents of theprogrammable control register.
上傳時間： 2014-12-28
上傳用戶：nshark
The PCA9519 is a 4-channel level translating I2C-bus/SMBus repeater that enables theprocessor low voltage 2-wire serial bus to interface with standard I2C-bus or SMBus I/O.While retaining all the operating modes and features of the I2C-bus system during thelevel shifts, it also permits extension of the I2C-bus by providing bidirectional buffering forboth the data (SDA) and the clock (SCL) lines, thus enabling the I2C-bus or SMBusmaximum capacitance of 400 pF on the higher voltage side. The SDA and SCL pins areover-voltage tolerant and are high-impedance when the PCA9519 is unpowered.
標簽： 4channel transla level 9519
上傳時間： 2013-11-19
上傳用戶：jisiwole
The PCA9544A provides 4 interrupt inputs, one for each channeland one open drain interrupt output. When an interrupt is generated byany device, it will be detected by the PCA9544A and the interruptoutput will be driven LOW. The channel need not be active fordetection of the interrupt. A bit is also set in the control byte.Bits 4 – 7 of the control byte correspond to channels 0 – 3 of thePCA9544A, respectively. Therefore, if an interrupt is generated byany device connected to channel 2, the state of the interrupt inputs isloaded into the control register when a read is accomplished.Likewise, an interrupt on any device connected to channel 0 wouldcause bit 4 of the control register to be set on the read. The mastercan then address the PCA9544A and read the contents of thecontrol byte to determine which channel contains the devicegenerating the interrupt. The master can then reconfigure thePCA9544A to select this channel, and locate the device generatingthe interrupt and clear it. The interrupt clears when the deviceoriginating the interrupt clears.
標簽： 4channel multiple 9544A 9544
上傳時間： 2014-12-28
上傳用戶：潛水的三貢
The PCA9542A is a 1-of-2 bidirectional translating multiplexer, controlled via the I2C-bus.The SCL/SDA upstream pair fans out to two SCx/SDx downstream pairs, or channels.Only one SCx/SDx channel is selected at a time, determined by the contents of theprogrammable control register. Two interrupt inputs, INT0 and INT1, one for each of theSCx/SDx downstream pairs, are provided. One interrupt output, INT, which acts as anAND of the two interrupt inputs, is provided.
上傳時間： 2013-12-07
上傳用戶：europa_lin
