通信：不同的獨立系統利用線路互相交換數據便是通信。通信的主要目的是將數據從一端發送到另一端，以實現數據的交換。網絡：構成整個通信的線路稱為網絡。計算機網絡：交換信息的系統若為計算機系統，則稱為計算機網絡（Computer Network）通信。發送端：就是根據協議將數據利用一定的程序通過線路發送出去。接收端：根據協議將數據收集起來并存儲或顯示在屏幕上
標簽： 串行通信
上傳時間： 2021-11-30
上傳用戶：
uninstall the device in the "Computer Management" pannel.在設備管理器中卸載已有驅動install PL2303-Prolific_DriverInstaller_v1200安裝壓縮包中的PL2303-Prolific_DriverInstaller_v1200restart your computer.重啟計算機
上傳時間： 2022-03-13
上傳用戶：jiabin
M.NT68676.2A is a monitor control board, which is suitable for Asia-Pacific market. It can supportLED/LCD panels which resolution is up to 2048×1152.M.NT68676.2A can synchronize with computer automatically. Synchronization requires thesynchronous signal which horizontal and vertical sync are separated.M.NT68676.2A can support dynamic contrast control, headphone input and Digital volume controlsimultaneously.
標簽： 樂華驅動板
上傳時間： 2022-03-13
上傳用戶：kent
本系統采用電動機電樞供電回路串接采樣電阻的方式來實現對小型直流有刷電動機的轉速測量。該系統主要由二階低通濾波電路,小信號放大電路、單片機測量顯示電路、開關穩壓電源電路等組成。同時自制電機測速裝置,用高頻磁環作為載體,用線圈繞制磁環,利用電磁感應原理檢測電機運行時的漏磁,將變化的磁場信號轉化為磁環上的感應電流。用信號處理單元電路將微弱電信號轉化為脈沖信號,送由單片機檢測,從而達到準確測量電機的速度的要求。In this system, the sampling resistance of armature power supply circuit is connected in series to measure the speed of small DC brush motor. The system is mainly composed of second-order low-pass filter circuit, small signal amplifier circuit, single-chip measurement and display circuit, switching regulated power supply circuit and so on. At the same time, the self-made motor speed measuring device uses high frequency magnetic ring as the carrier, coil winding magnetic ring, and electromagnetic induction principle to detect the leakage of magnetic field during the operation of the motor, which converts the changed magnetic field signal into the induced current on the magnetic ring. The weak electric signal is transformed into pulse signal by signal processing unit circuit, which is sent to single chip computer for detection, so as to meet the requirement of accurate measurement of motor speed.
標簽： 直流電動機
上傳時間： 2022-03-26
上傳用戶：
以倉庫智能改造為背景,主要介紹單片機和上位機之間通信網絡和通信協議的選擇,MODBUS協議通信指令和功能碼使用,重點闡述了基于RS-485總線的MODBUS通信協議在上位機和單片機之間的串行通信,實現上位機對單片機設備的遠程控制和信息采集的功能。Based on the intelligent warehouse transformation as the background,mainly introduces between MCU and PC communication network and the choice of communication protocol,instruction and the function code using the MODBUS protocol communication,expounds the MODBUS communication protocol based on RS-485 bus serial communication between PC and single chip microcomputer,PC remote control of single chip computer equipment and the function of information collection.
上傳時間： 2022-03-26
上傳用戶：
近年來反季節種植已成火熱趨勢,溫室大棚的普及十分迅速,而溫室大棚對自動化、智能化的要求也越來越迫切,本系統將溫室大棚的溫濕度、二氧化碳濃度各個方面的檢測,通風、澆灌、溫度、噴灑農藥等各個方面的控制進行綜合系統研究,實現溫室大棚對自動化、智能化的要求。這一系統是基于單片機控制的智能檢測,控制系統包含單片機主控模塊、感應檢測模塊、傳感模塊,顯示、控制模塊等[1]。從而提高溫室大棚的種植效率,減少勞動力,提高利潤等。In recent years,counter-season planting has become a hot trend featuring the rapid popularization of greenhouse and urgent requirement for the automation and intellectualization of greenhouse.This paper offers a comprehensive and systematic study of the monitoring of temperature,humidity and carbon dioxide concentration in the greenhouse and the control of ventilation,irrigation,temperature and pesticide spraying in order to achieve automation and intellectualization in greenhouse.This system is based on the intelligent detection controlled by single chip computer with the control system including the main control module,induction detection module,sensing module,display and control module of single chip computer,which is effective in improving planting efficiency of greenhouse,reducing labor force and increasing profits.
上傳時間： 2022-03-27
上傳用戶：
以AT89S52單片機為控制核心,采用電容降壓技術,Buck電路拓撲,PWM驅動模塊和功率器件散熱設計,通過高速的數據采集、主功率輸入輸出模塊和控制模塊,設計一種新型智能車載充電器.在充電過程中,通過負脈沖瞬間放電實現對鉛酸蓄電池的再生修復,提高電池的有效容量,延長使用壽命.該充電器體積小、速度快、效率高、可靠性好.With AT89S52 single chip computer as the control core,a new type of intelligent car-carried charger was designed by using capacitance step-down technology,Buck circuit topology,PWM driving module and power device heat dissipation design,through high-speed data acquisition,main power input and output module and control module.In the charging process,the regeneration and repair of lead-acid batteries are realized by instantaneous discharge of negative pulse,which improves the effective capacity of batteries and prolongs their service life.The charger has the advantages of small size,fast speed,high efficiency and good reliability.
標簽： 車載充電器
上傳時間： 2022-03-27
上傳用戶：
Algebra, Topology, Differential Calculus, and Optimization Theory For Computer Science and Machine Learning一本數學大全書，由Jean Gallier and Jocelyn Quaintance合著。
上傳時間： 2022-05-05
上傳用戶：默默
基于TMS320F28335的超聲波流量計硬件原理圖+軟件源碼本文以TMS320F28335 處理器為核心，設計一種用于管道流量測量的超聲波流量計。系統硬件由核心板，超聲波發射和接收電路，切換電路，超聲換能器，基于ADS805 的高速信號采集電路，人機交互以及電源等模塊構成。采用時差法進行管道流量測量，時差測量采用SCOT 加權的廣義互相關時延估計算法。本論文設計的超聲波流量計具有測量速度快、準確性好、成本低等優點。關鍵字：C2000，超聲波，流量，廣義互相關算法AbstractA kind of ultrasonic flowmeter using for the pipe flow measurement is designed based onTMS320F28335 in this paper. The system hardware consists of the following parts: the core board,ultrasonic signal transmitter and receiver circuits, switch circuit, ultrasonic transducer, signalacquisition circuit based on ADS805, human-computer interaction module and power supplymodule, etc. The system use the method of time difference for pipeline flow measurement and thetime difference is calculated by the time-delay algorithm of SCOT weighted generalizedcross-correlation. The ultrasonic flowmeter has the features of high testing speed, high precisionand low cost, etc.Keywords: C2000,Ultrasonic, Flow, Generalized Cross-Correlation Algorithm
標簽： tms320f28335 超聲波流量計
上傳時間： 2022-05-06
上傳用戶：
以STM32F103C8T6為核心,設計了無刷直流電機控制器硬件電路。電路主要包括IR2310構成的PWM驅動電路、IRF3808構成的逆變電路、增量式旋轉編碼構成的速度反饋電路。控制器具有CAN和RS232通信接口,可與計算機或PLC構成速度或位置伺服系統。利用由xPC目標搭建的半實物仿真平臺對PI參數進行整定。測試了控制器的速度伺服響應性能,給定速度為2400rpm時,控制器響應時間為0.32s。實驗結果表明,系統工作可靠,穩定性好,響應速度快,可以滿足上肢康復機器人的機械臂速度控制性能要求。The hardware circuit of Brushless DC motor controller is designed by taking STM32F103C8T6 as the core,which mainly includes PWM driving circuits made up of IR2310,inverter circuit formed by IRF3808,speed feedback circuit composed of incremental rotary encoder and so on.Speed servo control system or position servo control system can be composed of BLDM controller with computer or PLC through CAN communication interface or RS232 serial communication interface.By using the hardware in the loop simulation platform built by xPC target,the PI parameters are set up.The Speed servo response performance of the controller is tested.When the speed is 2 400 rpm,the response time of the controller is 0...
上傳時間： 2022-05-07
上傳用戶：
