基于DSP28035的高速永磁無刷直流電機驅動系統，包括論文和軟硬設計資料。摘要參賽作品為基于DSP28035的高速永磁無刷直流電機驅動系統。該系統以一臺額定轉速60 krpm的高速永磁無刷直流電機、交錯并聯的Buck電路以及全橋電路為硬件平臺，以DSP28035為控制核心，實現了調壓調速功能和基于坐標變換的無位置傳感器新技術。為實現該系統要求，本作品充分利用了DSP28035的資源例如：CLA模塊，模擬比較器、HPWM模塊以及AD轉換模塊等。AbstractThis work is the drive system for a high speed permanent magnet burshless dc motor based on DSP28035. The hardware platform consists of a BLDC motor(rated speed is 60000rpm), a Buck circuit and an inverter. Under the control of DSP28035, this system can achieve the goal of adjusting the motor’s speed with voltage and the function of sensorless control based on the coordinate transformation. By making full use of resources of the core, such as CLA, analog comparator, HPWM and AD converters, the whole system can meet the requirements.1 引言高速永磁無刷直流電機驅動系統由于基波頻率較高（一般在1kHZ以上），利用逆變橋斬波進行調速的控制方式通常會受到開關管開關頻率的限制，因此該系統多采用三相全橋前級加Buck電路進承擔調壓調速的功能，而三相全橋主要承擔邏輯換相的功能。然而，傳統Buck電路所需電感的體積較大，增加了系統的體積，降低了系統的功率密度。
上傳時間： 2022-05-08
上傳用戶：bluedrops
This manual documents the Microcontroller profile of version 7 of the ARM? Architecture, the ARMv7-M architecture profile. For short definitions of all the ARMv7 profiles see About the ARMv7 architecture, and architecture profiles on page A1-20.ARMv7 is documented as a set of architecture profiles. The profiles are defined as follows: ARMv7-A The application profile for systems supporting the ARM and Thumb instruction sets, and requiring virtual address support in the memory management model. ARMv7-R The realtime profile for systems supporting the ARM and Thumb instruction sets, and requiring physical address only support in the memory management model ARMv7-M The microcontroller profile for systems supporting only the Thumb instruction set, and where overall size and deterministic operation for an implementation are more important than absolute performance. While profiles were formally introduced with the ARMv7 development, the A-profile and R-profile have implicitly existed in earlier versions, associated with the Virtual Memory System Architecture (VMSA) and Protected Memory System Architecture (PMSA) respectively.
標簽： arm
上傳時間： 2022-06-02
上傳用戶：
The information disclosed to you hereunder (the Materials ) is provided solely for the selection and use of Xilinx products. To the maximum extent permitted by applicable law: (1) Materials are made available"AS IS"and with all faults, Xilinx hereby DISCLAIMS ALL WARRANTIES AND CONDITIONS, EXPRESS, IMPLIED, OR ST ATUTORY, INCLUDING BUT NOT LIMITED TO WARRANTIES OF MERCHANTABILITY NON-INFRINGEMENT, OR FITNESS FOR ANY PARTICULAR PURPOSE; and (2) Xilinx shall not be liable (whether in contract or tort. includina nealigence. or under anv other theorv of liabilitv) for any loss or damage of any kind or nature related to, arising under, or in connection with, the Materials (including vour use of the Materials), including for any direct, indirect, special, incidental, or consequential loss or damage (including loss of data, profits, qoodwill, or any type of loss or damage suffered as a result of anv action brought by a third party)
上傳時間： 2022-06-18
上傳用戶：
Spartane-6 LXand LXT FPGAs are available in various speed grades, with -3 having the highest performance. The DC and AC electrical parameters of the Automotive XA Spartan-6 FPGAs and Defense-grade Spartan-6Q FPGAs devices are equivalent to the commercial specifications except where noted. The timing characteristics of the commercial(XC)-2 speed grade industrial device are the same as for a-2 speed grade commercial device. The -2Q and -3Q speed grades are exclusively for the expanded(Q) temperature range. The timing characteristics are equivalent to those shown for the-2 and-3speed grades for the Automotive and Defense-grade devices.Spartan-6 FPGA DC and AC characteristics are specified for commercial (C), industrial (), and expanded (Q) temperature ranges. Only selected speed grades and/or devices might be available in the industrial or expanded temperature ranges for Automotive and Defense-grade devices.
上傳時間： 2022-06-19
上傳用戶：
le flows through MOS channel while Ih flows across PNP transistor Ih= a/(1-a) le, IE-le+lh=1/(1-a)' le Since IGBT has a long base PNP, a is mainly determined by ar si0 2ar= 1/cosh(1/La), La: ambipolar diff length a-0.5 (typical value)p MOSFET channel current (saturation), le=U"Cox"W(2"Lch)"(Vc-Vth)le Thus, saturated collector current Ic, sat=1/(1-a)"le=-1/(1-a)"UCox"W/(2Lch)"(Vo-Vth)2Also, transconductance gm, gm= 1/(1-a)"u' Cox W/Lch*(Vo-Vth)Turn-On1. Inversion layer is formed when Vge>Vth2. Apply positive collector bias, +Vce3. Electrons flow from N+ emitter to N-drift layer providing the base current for the PNP transistor4. Since J1 is forward blased, hole carriers are injected from the collector (acts as an emitter).5. Injected hole carriers exceed the doping level of N-drift region (conductivity modulation). Turn-Off1. Remove gate bias (discharge gate)2. Cut off electron current (base current, le, of pnp transistor)
標簽： igbt
上傳時間： 2022-06-20
上傳用戶：wangshoupeng199
INTRODUCTION In the past, adding speech recording and playback capability to a product meant using a digital signal processor or a specialized audio chip. Now, using a simplified Adaptive Differential Pulse Code Modulation(ADPCM) algorithm, these audio capabilities can be added to any PICmicro device. This application note will cover the ADPCM compression and decompression algorithms, performance comparison of all PICmicro devices, and an application using a PIC16C72 micro-controller.DEFINITION OF TERMS step size -value of the step used for quantization of ana-log signals and inverse quantization of a number of steps.quantization -the digital form of an analog input signal is represented by a finite number of steps.adaptive quantization -the step size of a quantizer is dramatically changed with time in order to adapt to a changing input signal.inverse quantizer -a finite number of steps is converted into a digital representation of an analog signal.
上傳時間： 2022-06-20
上傳用戶：
通訊工具FTPLINK的源代碼，適用于文曲星與電腦間的串口通訊。原作者為L(zhǎng)-Communication FTPLINK the source code for Wenquxing from the c
標簽： ftplink
上傳時間： 2013-04-24
上傳用戶：1109003457
詳細介紹了VC下利用WINDOWS API函數來實現與符合HID設備類的USB接口通信，并給出了通信程序的部分源代碼-details of VC using Windows API function
上傳時間： 2013-07-13
上傳用戶：whenfly
A MEMS microphone IC is unique among Analog Devices, Inc., products in that its input is an acoustic pressure wave. For this reason, some specifications included in the data sheets for these parts may not be familiar, or familiar specifications may be applied in unfamiliar ways. This application note explains the specifica-tions and terms found in MEMS microphone data sheets so that the microphone can be appropriately designed into a system.
標簽： MEMS 麥克風 系統設計 效率
上傳時間： 2013-10-31
上傳用戶：masochism
Many 8-bit and 16-bit microcontrollers feature 10-bitinternal ADCs. A few include 12-bit ADCs, but these oftenhave poor or nonexistent AC specifi cations, and certainlylack the performance to meet the needs of an increasingnumber of applications. The LTC®2366 and its slowerspeed versions offer a high performance alternative, asshown in the AC specifi cations in Table 1. Compare theseguaranteed specifi cations with the ADC built into yourcurrent microcontroller.
上傳時間： 2013-10-26
上傳用戶：jackandlee
蟲蟲下載站版權所有 京ICP備2021023401號-1
