Routine mampres: To obtain Amplitude response from h(exp(jw)). input parameters: h :n dimensioned complex array. the frequency response is stored in h(0) to h(n-1). n :the dimension of h and amp. fs :sampling frequency (Hz). iamp:If iamp=0: The Amplitude Res. amp(k)=abs(h(k)) If iamp=1: The Amplitude Res. amp(k)=20.*alog10(abs(h(k))). output parameters: amp :n dimensioned real array. the Amplitude-frequency response is stored in amp(0) to amp(n-1). Note: this program will generate a data file "filename.dat" . in chapter 2
標簽： dimensione parameters Amplitude response
上傳時間： 2013-12-19
上傳用戶：xfbs821
This m file analyzes a coherent binary phase shift keyed(BPSK) and a Amplitude shift keyed(ASK) communication system. The receiver uses a correlator(mixer-integrator[LPF]) configuration with BER measurements comparing measured and theoretical results. The bandpass and low pass used in the receiver are constructed using z transforms.
標簽： keyed shift Amplitude analyzes
上傳時間： 2015-09-26
上傳用戶：liuchee
We address the problem of blind carrier frequency-offset (CFO) estimation in quadrature Amplitude modulation, phase-shift keying, and pulse Amplitude modulation communications systems.We study the performance of a standard CFO estimate, which consists of first raising the received signal to the Mth power, where M is an integer depending on the type and size of the symbol constellation, and then applying the nonlinear least squares (NLLS) estimation approach. At low signal-to noise ratio (SNR), the NLLS method fails to provide an accurate CFO estimate because of the presence of outliers. In this letter, we derive an approximate closed-form expression for the outlier probability. This enables us to predict the mean-square error (MSE) on CFO estimation for all SNR values. For a given SNR, the new results also give insight into the minimum number of samples required in the CFO estimation procedure, in order to ensure that the MSE on estimation is not significantly affected by the outliers.
標簽： frequency-offset estimation quadrature Amplitude
上傳時間： 2014-01-22
上傳用戶：牛布牛
ML Estimation of frequency, phase, and Amplitude of a sinusoid from discrete time samples MLEsim.m
標簽： Estimation frequency Amplitude discrete
上傳時間： 2014-12-07
上傳用戶：dianxin61
This MATLAB code simulates the effects of Amplitude variation between modulators for the wireless LO.該程序分析由于本振信號幅度動態變化對調制器的影響。
標簽： modulators Amplitude simulates the
上傳時間： 2016-12-09
上傳用戶：pinksun9
Code for the Quadrature Amplitude modulation
標簽： Quadrature modulation Amplitude Code
上傳時間： 2013-12-24
上傳用戶：franktu
Quadrature Amplitude Modulation (QAM）在MATLAB的仿真和應用
標簽： Quadrature Modulation Amplitude MATLAB
上傳時間： 2017-04-20
上傳用戶：er1219
This file is a function under matlab which allow to compute and plot Amplitude modulation : AM. We can observe the effect of the information parameter can be changed such as Amplitude and modulation ratio m.
標簽： modulation Amplitude function compute
上傳時間： 2017-06-27
上傳用戶：cooran
Amplitude modulation system using simulink matlab
標簽： modulation Amplitude simulink matlab
上傳時間： 2017-08-15
上傳用戶：ruixue198909
SVD coefficient matrix from matrix of Amplitude values
標簽： matrix coefficient Amplitude values
上傳時間： 2017-08-21
上傳用戶：大融融rr
