在電源設計中，工程人員時常會面臨控制 IC 驅動電流不足的問題，或者因為閘極驅動損耗導致控制 IC 功耗過大。為解決這些問題，工程人員通常會採用外部驅動器。目前許多半導體廠商都有現成的 MOSFET 積體電路驅動器解決方案，但因為成本考量，工程師往往會選擇比較低價的獨立元件。
上傳時間： 2013-11-19
上傳用戶：阿譚電器工作室
CMOS 邏輯系統的功耗主要與時脈頻率、系統內各閘極輸入電容及電源電壓有關，裝置尺寸縮小後，電源電壓也隨之降低，使得閘極大幅降低功耗。這種低電壓裝置擁有更低的功耗和更高的運作速度，因此系統時脈頻率可升高至 Ghz 範圍。
上傳時間： 2013-10-14
上傳用戶：immanuel2006
透過增加輸入電容，可以在獲得更多鏈波電流的同時，還能藉由降低輸入電容的壓降來縮小電源的工作輸入電壓範圍。這會影響電源的變壓器圈數比以及各種電壓與電流應力(current stresscurrent stress current stresscurrent stress current stress current stress )。電容鏈波電流額定值越大，應力越小，電源效率也就越高。
上傳時間： 2013-11-11
上傳用戶：jelenecheung
開關電源設計資料
上傳時間： 2013-11-08
上傳用戶：李哈哈哈
移動電源方案功能要求: 1、單芯片控制充電、升壓輸出、電量指示功能，輸出電流可達1A，效率90%以上 按開關鍵開機6燈頻閃幾次后待機， LI為充電指示，L2頻閃指示有輸出。L2I常亮為輸出充滿指示，L3-L6為電量指示。在輸出時L2頻閃。充電時LI頻閃。當有負載設備連接時自動輸出，無負載電流轉為待機。 當按開關工作后，無負載（無操作）10秒自動關機。 2、移動電源方案，單芯片控制為內電池充電、升壓輸出、電量顯示、邊充邊放；輸入電壓5V、300-1000MA，輸出電壓5V、；輸出電流可達1A，輸出效率90%以上 1）、電性能參數： USB輸入電壓：DC 5V 輸出DC5V
上傳時間： 2013-11-19
上傳用戶：wangfei22
The CN3052A is a complete constant-current /constant voltage linear charger for single cell Li-ion and Li Polymer rechargeable batteries. The device contains an on-chip power MOSFET and eliminates the need for the external sense resistor and blocking diode.
上傳時間： 2013-11-10
上傳用戶：子虛烏有
Linear Technology offers a variety of devices that simplifyconverting power from a USB cable, but the LTC®3455represents the highest level of functional integration yet. The LTC3455 seamlessly manages power flowbetween an AC adapter, USB cable and Li-ion battery,while complying with USB power standards, all from a4mm × 4mm QFN package. In addtion, two high efficiencysynchronous buck converters generate low voltage railswhich most USB-powered peripherals require. TheLTC3455 also provides power-on reset signals for themicroprocessor, a Hot SwapTM output for poweringmemory cards as well as an uncommitted gain blocksuitable for use as a low-battery comparator or an LDOcontroller. The PCB real estate required for the entire USBpower control circuit and two DC/DC converters is only225mm2.
上傳時間： 2013-11-02
上傳用戶：名爵少年
Although recent popular attention is focused on LithiumIon batteries, one must not forget that other batterychemistries, such as Nickel Cadmium (NiCd) and NickelMetal Hydride (NiMH) have advantages in rechargeablepower systems. Nickel-based batteries are robust, capableof high discharge rates, have good cycle life, do notrequire special protection circuitry and are less expensivethan Li-Ion. Among the two, NiMH batteries are rapidlyreplacing NiCd because of their higher capacity (40% to50% more) and the environmental concerns of the toxiccadmium contained in NiCd batteries.
上傳時間： 2013-11-04
上傳用戶：qq10538412
A number of conventional solutions have been available forthe design of a DC/DC converter where the output voltageis within the input voltage range—a common scenarioin Li-Ion battery-powered applications—but none werevery attractive until now. Conventional topologies, suchas SEPIC or boost followed by buck, have numerousdisadvantages, including low effi ciency, complex magnetics,polarity inversion and/or circuit complexity/cost. TheLTC®3785 buck-boost controller yields a simple, effi cient,low parts-count, single-converter solution that is easyto implement, thus avoiding the drawbacks associatedwith traditional solutions.
上傳時間： 2013-10-21
上傳用戶：ljt101007
The LTC®3562 quad output step-down regulator is designedfor multicore handheld microprocessor applications thatoperate from a single Li-Ion battery. Its four monolithic, higheffi ciency buck regulators support Intel’s mobile CPU P-Stateand C-State energy saving operating modes. The outputvoltages are independently controllable via I2C, and eachoutput can be independently started and shut down. Designerscan choose from power saving pulse-skipping mode orBurst Mode® operation, or select low noise LDO mode. Thespace-saving LTC3562 is available in a 3mm × 3mm QFNpackage and requires few external components.
上傳時間： 2013-10-07
上傳用戶：1583060504
