介紹了采用ATmega48單片機實現三相無刷直流電機控制器的方法。利用Atmega48獲得帶死區的脈寬調制（PWM）、霍爾傳感器的換相處理、正弦驅動信號的產生和電機轉速的控制等功能。采用該方法的優點是所需的外圍器件少，成本低。 Abstract: The method of 3-phase brushless DC motor control based on ATmega48 is presented in this paper.The system uses ATmega48 to generate PWM signals with dead-time, hall sensors signals commutation，sine driving signal and rotational speed of motor.Using this method，the needed external devices are few, the cost is low.
標簽： ATmega 48 無刷電機 控制方法
上傳時間： 2013-12-09
上傳用戶：330402686
介紹一種簡單射頻識別系統設計。該設計包括閱讀器、應答器和線圈3部分。由單片機控制閱讀器向應答器發射無線信號，并接收應答器回送的信號，再通過分析回送信號識別物品。閱讀器和應答器之間以半雙工通信方式通信。 Abstract: A simple design of radio frequency identification system is given in this paper.The design includes reader,responder and winding.Through MCU，signals are sent to responder from reader，then corresponding signals are sent back. According to the analysis of the signals sent back，the objects can be identified.Half-duplex communication is adopted? between? reader? and? responder.
標簽： 51單片機 無線識別 裝置
上傳時間： 2013-10-11
上傳用戶：plsee
氣壓是氣象監測中的一個重要參數，提出了一種氣壓數據采集模塊設計方案，該模塊采用數字氣壓傳感器MS5534B、MSP430單片機MSP430F2272和帶實時時鐘（RTC）64 KB鐵電存儲器。通過低功耗軟件設計方法以微安級整體平均功耗實現了氣壓數據的采集和存儲，適合電池供電的連續高精度氣壓采集應用。給出了模塊的軟硬件設計以及MS5534B的性能指標和使用經驗。 Abstract: Air pressure is an important parameter in weather monitor.This paper futs forward a new design scheme of low power-air pressure data acquisition module.The module uses a digital output barometer sensor MS5534B,MSP430 microcontroller MSP430F2272 and integrated RTC 64KB FRAM,precision air pressure measurement and storage chip.Another point of this module is low power consumption, so it is well suited for battery powered air pressure data acquisition applications. At the same time,the software and hardware deign of module is presented,And the speciaties and use notices of MS5534B are given.
上傳時間： 2014-12-27
上傳用戶：drink！
采用單片機AT89C2051實現溫度測量與控制,鍵盤和顯示電路實現溫度的設定、修改、清零以及當前溫度值的顯示,并對溫度超過上下限進行報警。闡述了該系統設計的硬件和軟件設計。 Abstract: The system of temperature measuring and controling is realized based on AT89C2051.The keyboard and display circuit is designed,which can be used for setting and modifying temperature value,resetting and displaying the present temperature value.At the same time the warning circuit is also designed in the system,which can deal with the alarm when temperature exceeds the upper limit and the lower limit.The hardware and software design of the system are explained．
上傳時間： 2013-11-18
上傳用戶：leehom61
針對眾多低成本數據采集需求，采用帶有片上USB控制器和D/A轉換器的混合信號微處理器C8051F340，設計了一款可通過USB接口和LabVIEW圖形用戶界面實現與PC機聯機的數據采集器，同時借助系統的SD卡存儲獨立實現現場長時間采集數據。該數據采集器成本低，結構簡單，體積小，已成功用于工業現場。 Abstract: Aiming at the need of low cost data acquisition, a data acquisition device is designed based on C8051F340 which is a mixed-signal microcontroller and integrates USB controller and A/D controller on a chip.The data acquisition device which can combine with PC by USB interface and LabVIEW graphical user interface,can realize data acquisition. At the same time,it can be solely run a long time in virtue of SD card in field.The date aequisition device features low cost,simple structure and little sharp, and it has been used in industry field.
標簽： C8051F340 數據 集器設計
上傳時間： 2014-05-31
上傳用戶：1109003457
介紹一種無極可調交流電子負載設計的新方法，由ATmega48單片機輸出PWM波，通過上位機設定不同的占空比控制場效應管的通斷時間，即改變流過場效應管的平均電流。根據電流的大小，可以等效為相應的負載，并將采集的電流值顯示在上位機上。文中對該系統的軟﹑硬件設計思路作了詳細的分析，闡述了其設計原理。 Abstract: A new type electronic load is introduced.Due to ATmega48 microcomputer output PWM wave.The different duty is set ratio through PC to control FET turn-on time.We can equivalent homologous load according the current and display the current at PC.The hardware and software designing are analysed in detail. The principle is explained and the output is also given.
標簽： ATmega 48 單片機 交流電子
上傳時間： 2013-11-23
上傳用戶：蟲蟲蟲蟲蟲蟲
對于傳統的跑步機無法聯機組網，保存歷史數據，實時調試等問題，介紹了一個由多臺跑步機通過RS-232串行總線與上位機相連組成的跑步機聯網系統。系統采用W77E58作為下位機核心控制器件，它具有雙串行通訊端口，其中一個串口用于與變頻器通訊，另一個串口則與上位機相連，構成跑步機網絡。 Abstract: The traditional running machine can not be connected to a network, saving historical data, real time debug etc.In this paper,a new network system which is composed of running machines connected by a RS-232 communication bus is introduced.In the system,W77E58 is used as a core control unit.W77E58 has two serial ports,one is connected to the inverter and the other is connected to the PC. Thus a network appears.
標簽： W77E58 跑步機 聯網系統
上傳時間： 2014-12-27
上傳用戶：哇哇哇哇哇
詳細介紹了TLC1549系列模數轉換器的特點及工作原理，然后根據TLC1549的工作時序和A/D轉換原理針對實際問題編寫了詳細的匯編語言程序。 Abstract: A basic principle and characteristic of TLC1549 analog-to-digital converter are introduced? detailedly in this article.Through engineering-oriented illustration,a microcomputer programmer base on basic principle and time sequence of TLC1549 is writted.
上傳時間： 2014-07-16
上傳用戶：blans
介紹一種以MSP430單片機為基礎的智能頻率測量系統，采用硬件邏輯與軟件指令相結合的方式控制閘門，實現0 MHz~10 MHz范圍內無檔切換的等精度測量。 Abstract: An intelligent frequency measurement system based on MSP430 singlechip is introduced. The system uses a way that can combine hardware logic and software instructions to contronl the strobe ,and completes the functions of equal precision in the range of 0MHz~10MHz without shifting
上傳時間： 2013-10-28
上傳用戶：dbs012280
對于瀝青混凝土攤鋪機自動找平控制系統來說，數字式控制系統的研制是目前的一個方向。介紹了一種基于CAN總線的數字式自動找平控制系統。該系統以CAN總線作為通信方式，PWM控制信號通過C8051F040單片機內部PCA可編程計數器陣列產生，并具有結構簡單、信號穩定、實時性強、易擴展的特點。通過硬件實現和系統運行達到了比較理想的控制效果，驗證了系統的可行性。 Abstract: A digital auto-leveling control system based on CAN Bus is introduced.It uses CAN Bus as the method of communication and creates PWM signals by programmable counter array in C8051F040 microcontroller. The system is simple, stable, real-time and expansive.
標簽： CAN 總線 數字式 控制系統設計
上傳時間： 2013-10-09
上傳用戶：ligi201200
蟲蟲下載站版權所有 京ICP備2021023401號-1
