M-file uses random data which BPSK modulates a carrier to configure a BPSK UWB transmitter. The receiver demodulates the BPSK UWB carrier and the data is recovered.
Coaxial feed structures are widely used in ultra-wide band antennas . This paper modeled the characteristic of the monopole antenna feeded by coaxial line by FDTD in the time-domiain,which showes that . Firstly, it introduced the theory of the arithmetic and the particularly realization in the calculation then it described the use in the time-domain finally it analysed several characteristics of the monopole antenna. The arithmetic used in the microstrip antenna is also a quick and economical way to design the antenna.
pashload是應用在linux下的網絡帶寬測試源程序精確度比較高
/////////////////////////////////////
Pathload is a tool for estimating the available bandwidth
of an end-to-end path from a host S (sender) to a host R (receiver).
The available bandwidth is the maximum IP-layer
throughput that a flow can get in the path from S to R,
without reducing the rate of the rest of the traffic in the path.
The MAX481E, MAX483E, MAX485E, MAX487E–MAX491E,
and MAX1487E are low-power transceivers for RS-485 and
RS-422 communications in harsh environments. Each driver
output and receiver input is protected against ±15kV electrostatic
discharge (ESD) shocks, without latchup. These parts
contain one driver and one receiver. The MAX483E,
MAX487E, MAX488E, and MAX489E feature reduced slewrate
drivers that minimize EMI and reduce reflections caused
by improperly terminated cables, thus allowing error-free
data transmission up to 250kbps. The driver slew rates of the
MAX481E, MAX485E, MAX490E, MAX491E, and MAX1487E
are not limited, allowing them to transmit up to 2.5Mbps.
The idea behind differential GPS is to remove as much errors as possible from the range measurements by establishing these errors at a reference site. In its most simple setup, a GPS receiver is located at a well surveyed position and its (pseudo) range measurements are compared with the actual calculated range from this receiver to the SV s. The differences between measured ranges and calculated ranges at the reference receiver are applied as corrections to the ranges measured by other receiver(s) close by.
