PCA9546A 是一款I2C 多路復用器和開關，能實現I2C 總線擴展、電平轉換及總線功能恢復
上傳時間： 2013-12-02
上傳用戶：myworkpost
The PCA9547 is an octal bidirectional translating multiplexer controlled by the I2C-bus.The SCL/SDA upstream pair fans out to eight downstream pairs, or channels. Only oneSCx/SDx channel can be selected at a time, determined by the contents of theprogrammable control register. The device powers up with Channel 0 connected, allowingimmediate communication between the master and downstream devices on that channel.
上傳時間： 2014-12-28
上傳用戶：270189020
The PCA9548A is an octal bidirectional translating switch controlled via the I2C-bus. TheSCL/SDA upstream pair fans out to eight downstream pairs, or channels. Any individualSCx/SDx channel or combination of channels can be selected, determined by thecontents of the programmable control register.An active LOW reset input allows the PCA9548A to recover from a situation where one ofthe downstream I2C-buses is stuck in a LOW state. Pulling the RESET pin LOW resets theI2C-bus state machine and causes all the channels to be deselected as does the internalPower-on reset function.
上傳時間： 2013-10-13
上傳用戶：bakdesec
The PCA9557 is a silicon CMOS circuit which provides parallel input/output expansion for SMBus and I2C-bus applications. The PCA9557 consists of an 8-bit input port register, 8-bit output port register, and an I2C-bus/SMBus interface. It has low current consumption and a high-impedance open-drain output pin, IO0. The system master can enable the PCA9557’s I/O as either input or output by writing to the configuration register. The system master can also invert the PCA9557 inputs by writing to the active HIGH polarity inversion register. Finally, the system master can reset the PCA9557 in the event of a time-out by asserting a LOW in the reset input. The power-on reset puts the registers in their default state and initializes the I2C-bus/SMBus state machine. The RESET pin causes the same reset/initialization to occur without de-powering the part.
上傳時間： 2014-01-18
上傳用戶：bs2005
PCA9698 是一款40 位I2C 輸入/輸出擴展器，能夠實現I2C/SMBus 應用中40 位GPIO 的擴展
上傳時間： 2013-11-21
上傳用戶：文993
關鍵詞 CAN報文對象的FIFO模式應用摘 要 CAN通信實驗
上傳時間： 2013-11-03
上傳用戶：kernor
The P82B715 I2C Buffer was designed toextend the range of the local I2C bus out to50 Meters. This application note describesthe results of testing the buffer on severaldifferent types of cables to determine themaximum operating distances possible. Theresults are summarized in a table for easyreference.
標簽： extender P82B715 Using I2C
上傳時間： 2014-12-28
上傳用戶：lou45566
I2C BUS（Inter IC BUS）是NXP 推出的芯片間串行傳輸總線，它以2 根連線實現了完善的雙向同步數據傳送，可以極方便地構成多機系統和外圍器件擴展系統。I2C 總線采用了器件地址的硬件設置方法，通過軟件尋址完全避免了器件的片選線尋址方法，從而使硬件系統具有最簡單而靈活的擴展方法。I2C 總線的2 根線（串行數據——SDA，串行時鐘——SCL）連接到總線上的任何一個器件，每個器件都應有一個唯一的地址，而且都可以作為一個發送器或接收器。此外，器件在執行數據傳輸時也可以被看作是主機或從機。
上傳時間： 2013-11-05
上傳用戶：qb1993225
本實驗是基于EasyFPGA030的I2C總線接口模塊設計，用EasyFPGA030開發套件通過I2C協議實現對二線制I2C串行EEPROM的讀寫操作，先把數據寫入EEPROM，然后再讀取出來顯示在數碼管上
上傳時間： 2013-10-21
上傳用戶：edisonfather
關鍵詞 CAT9534、I2C 總線、SMBus、I/O 擴展器摘 要CAT9534 是一款帶中斷的8 位并行I2C/SMBus 輸入/輸出端口擴展器件
上傳時間： 2013-10-21
上傳用戶：rocwangdp
