The decoding algorithm used in RBDS.c is based on error trapping. The program emulates the operation of the encoder and decoder of a binary cyclic codes, using bitwise shifts and xor for modulo g(x) operations.
標簽： The algorithm operation decoding
上傳時間： 2015-07-05
上傳用戶：youmo81
DOSBox emulates a full x86 pc with sound and dos. Its main use is to run old dosgames on platforms which don t have dos(win2K/XP/linux/FreeBSD/Mac OS X)
標簽： platforms emulates dosgames DOSBox
上傳時間： 2015-11-14
上傳用戶：TRIFCT
The driver supports both the 16F and 18F families. The trick is that the driver carefully emulates the hardware UART found in the PIC18F452 processor. This information has unfortunately misled some into thinking it does not work with the 16F family. During devlopment the driver was tested on a real PIC16F84A (as opposed to software emulation). To make sure nothing has been broken, I have just recompiled the code using SourceBoost 6.0 and it compiled without error.
上傳時間： 2013-12-19
上傳用戶：diets
The C500 microcontroller family usually provides only one on-chip synchronous serialchannel (SSC). If a second SSC is required, an emulation of the missing interface mayhelp to avoid an external hardware solution with additional electronic components.The solution presented in this paper and in the attached source files emulates the mostimportant SSC functions by using optimized SW routines with a performance up to 25KBaud in Slave Mode with half duplex transmission and an overhead less than 60% atSAB C513 with 12 MHz. Due to the implementation in C this performance is not the limitof the chip. A pure implementation in assembler will result in a strong reduction of theCPU load and therefore increase the maximum speed of the interface. In addition,microcontrollers like the SAB C505 will speed up the interface by a factor of two becauseof an optimized architecture compared with the SAB C513.Moreover, this solution lays stress on using as few on-chip hardware resources aspossible. A more excessive consumption of those resources will result in a highermaximum speed of the emulated interface.Due to the restricted performance of an 8 bit microcontroller a pin compatible solution isprovided only; the internal register based programming interface is replaced by a set ofsubroutine calls.The attached source files also contain a test shell, which demonstrates how to exchangeinformation between an on-chip HW-SSC and the emulated SW-SSC via 5 external wiresin different operation modes. It is based on the SAB C513 (Siemens 8 bit microcontroller).A table with load measurements is presented to give an indication for the fraction of CPUperformance required by software for emulating the SSC.
標簽： synchronous Emulating serial
上傳時間： 2014-01-31
上傳用戶：z1191176801
The solution presented in this paper and in the attached source files emulates the mostimportant SSC functions by using SW routines implemented in C. The code is focused onthe SAB C513, but will fit to all C500 derivatives.Beyond the low level software drivers a test shell is delivered. This shell allows a quicktest of the software drivers by an emulator or a starter kit demo board.
上傳時間： 2013-11-24
上傳用戶：363186
tty驅動 * This driver shows how to create a minimal tty driver. It does not rely on * any backing hardware, but creates a timer that emulates data being received * from some kind of hardware.
標簽： driver tty backing minimal
上傳時間： 2013-12-04
上傳用戶：金宜
