首先下載軟件，解壓軟件，安裝在程序中找到SEGGER,選里面的J-FLASH，進入界面，剛開始的那個界面可以忽略，不用建project也可以；單擊菜單欄的“Options---Project settings”打開設置，進行jlink配置;正在General選項，選擇“USB”，一般都是默認配置，確認一下即可;然后在CPU選項，選擇芯片型號，先選擇“Device”才能選擇芯片型號，芯片型號，要根據你使用的芯片進行選擇;在Target interface選項 里面選擇SWD模式;首先Target里面選“Connection”連接目標芯片，然后 Target--Auto進行程序燒寫;首先Target里面選擇“Connection”連接目標芯片，然后 Target--Auto進行程序燒寫.SEGGER J-Links are the most widely used line of debug probes available today. They've proven their value for more than 10 years in embedded development. This popularity stems from the unparalleled performance, extensive feature set, large number of supported CPUs, and compatibility with all popular development environments.
標簽： JLINK
上傳時間： 2022-03-22
上傳用戶：
本系統采用電動機電樞供電回路串接采樣電阻的方式來實現對小型直流有刷電動機的轉速測量。該系統主要由二階低通濾波電路,小信號放大電路、單片機測量顯示電路、開關穩壓電源電路等組成。同時自制電機測速裝置,用高頻磁環作為載體,用線圈繞制磁環,利用電磁感應原理檢測電機運行時的漏磁,將變化的磁場信號轉化為磁環上的感應電流。用信號處理單元電路將微弱電信號轉化為脈沖信號,送由單片機檢測,從而達到準確測量電機的速度的要求。In this system, the sampling resistance of armature power supply circuit is connected in series to measure the speed of small DC brush motor. The system is mainly composed of second-order low-pass filter circuit, small signal amplifier circuit, single-chip measurement and display circuit, switching regulated power supply circuit and so on. At the same time, the self-made motor speed measuring device uses high frequency magnetic ring as the carrier, coil winding magnetic ring, and electromagnetic induction principle to detect the leakage of magnetic field during the operation of the motor, which converts the changed magnetic field signal into the induced current on the magnetic ring. The weak electric signal is transformed into pulse signal by signal processing unit circuit, which is sent to single chip computer for detection, so as to meet the requirement of accurate measurement of motor speed.
標簽： 直流電動機
上傳時間： 2022-03-26
上傳用戶：
隨著光伏發電系統快速發展,以及電動汽車充電樁的普及,傳統的剩余電流保護器無法滿足實際需求。介紹了一款B型剩余電流保護器,采用磁調制剩余電流互感器和零序電流互感器采集剩余電流。根據GB/T 22794—2017標準要求,可識別1 kHz及以下的正弦交流、帶和不帶直流分量的脈動直流、平滑直流等剩余電流信號。經信號調理電路將電壓信號送到單片機進行采集和判斷。通過試驗測試,該樣機在測試精度和速度上均符合國家標準的相關要求。The rapid development of photovoltaic power generation systems and the popularity of electric vehicle charging piles make the traditional residual current protective devices unable to meet the actual demand.This paper proposed a type B residual current protective device,which uses the magnetically modulated residual current transformer and the zero sequence current transformer to acquire the residual current.According to the requirements of GB/T 22794—2017,the type B residual current protective device can detect sinusoidal AC residual current of 1kHz and below 1kHz,pulsating DC residual current with and without DC component,smooth DC residual current and so on.The signal processing circuit sends the voltage signal to the MCU for acquisition and judgment.Through experimental tests,the device meets the relevant requirements of national standards in terms of test accuracy and speed.
標簽： 電流保護器
上傳時間： 2022-03-27
上傳用戶：
以AT89S52單片機為控制核心,采用電容降壓技術,Buck電路拓撲,PWM驅動模塊和功率器件散熱設計,通過高速的數據采集、主功率輸入輸出模塊和控制模塊,設計一種新型智能車載充電器.在充電過程中,通過負脈沖瞬間放電實現對鉛酸蓄電池的再生修復,提高電池的有效容量,延長使用壽命.該充電器體積小、速度快、效率高、可靠性好.With AT89S52 single chip computer as the control core,a new type of intelligent car-carried charger was designed by using capacitance step-down technology,Buck circuit topology,PWM driving module and power device heat dissipation design,through high-speed data acquisition,main power input and output module and control module.In the charging process,the regeneration and repair of lead-acid batteries are realized by instantaneous discharge of negative pulse,which improves the effective capacity of batteries and prolongs their service life.The charger has the advantages of small size,fast speed,high efficiency and good reliability.
標簽： 車載充電器
上傳時間： 2022-03-27
上傳用戶：
溫度控制如今已成為當代社會研究的熱點之一,而溫度檢測在現代設備參數檢測中也是一項極其重要的技術,應用十分廣泛。與傳統的測溫方法相比,紅外測溫方法具有時間短、精度高、使用簡單方便等優點。本文以環境溫度為被測對象,設計了以STC89C52單片機為控制中心的紅外測溫裝置,能夠實現對目標溫度的實時采集、處理、顯示和報警等功能。本設計主要是由STC89C52單片機、紅外測溫傳感器、LCD1602液晶顯示器、按鍵和蜂鳴器等部分組成,采用非接觸的方式對目標溫度進行實時檢測。Temperature control has become one of the hotspots in contemporary social research,and temperature detection is an extremely important technology in modern equipment parameter detection.Compared with traditional method,the infrared temperature measuring method has advantages of short time,high precision and convenient operation,etc.This paper consider environment temperature as research objects and designs an infrared temperature measuring device which employs the STC89C52singlechipas-control center,and it can realize timely collection,processing,display and alarm function of the target temperature.The design is mainly composed of STC89C52 singlechip,infrared temperature sensor,LCD1602monitor,keys and buzzer,etc.This design detects the target temperature by non-contact method.
上傳時間： 2022-03-27
上傳用戶：jiabin
本系統基于STM32單片機設計的非接觸式電流檢測控制系統,通過OPA548片將所給任意信號放大,由100Ω電阻和INA128芯片進行電流電壓轉換放大后,利用STM32單片機對獲取的電壓信號以0.488μs頻率采樣,利用STM32單片機的FFT庫,獲得信號的諧波信息。測量電流信號精準,該設計可廣泛應用在以STM32單片機為核心控制器件的新型儀表中,性能精準且抗干擾能力強。This system is a non-contact current detection and control system based on STM32 single chip microcomputer. It amplifiesany signal through OPA548 chip, converts and amplifies the current and voltage by 100 Ω resistance and INA128 chip. The obtainedvoltage signal is sampled at the frequency of 0.488 μs by STM 32 single chip microcomputer, and the harmonic information of the signalis obtained by the FFT library of STM 32 single chip microcomputer. The measurement of current signal is accurate. This design can bewidely used in a new instrument with STM 32 single chip microcomputer as its core control device, with accurate performance and stronganti-interference capability.
上傳時間： 2022-03-27
上傳用戶：
入室搶劫事件屢見不鮮,針對此現象進行分析不難發現,造成失竊事件的極大原因是人們慵懶和意識差等不良性格造成習慣性不鎖門.本文以STC89C52單片機為基礎,設計了一種基于人體紅外傳感器的自動關門鎖門裝置,來解決此類問題.The incidents of burglary are so common. It is not difficult to find that the main reason for the burglary is the habit of unlocking of doors caused by people's laziness and poor consciousness. Based on the single chip microcomputer of STC89C52, a device used with infrared sensor of human body is introduced in this paper, which can achieve the effect of automatic closing and locking doors.
上傳時間： 2022-03-27
上傳用戶：canderile
數字示波器功能強大,使用方便,但是價格相對昂貴。本文以Ti的MSP430F5529為主控器,以Altera公司的EP2C5T144C8 FPGA器件為邏輯控制部件設計數字示波器。模擬信號經程控放大、整形電路后形成方波信號送至FPGA測頻,根據頻率值選擇采用片上及片外高速AD分段采樣。FPGA控制片外AD采樣并將數據輸入到FIFO模塊中緩存,由單片機進行頻譜分析。測試表明:簡易示波器可以實現自動選檔、多采樣率采樣、高精度測頻及頻譜分析等功能。Digital oscilloscope is powerful and easy to use, but also expensive. The research group designed a low-cost digital oscilloscope, the chip of MSP430F5529 of TI is chosen as the main controller and the device of EP2C5T144C8 of Altera company is used as the logic control unit. Analog signal enter the programmable amplifier circuit, shaping circuit and other pre-processing circuit. The shaped rectangular wave signal is sent to FPGA for measure the frequency. According to the frequency value to select AD on-chip or off-chip high-speed AD for sampling. FPGA controls the off-chip AD sampling and buffers AD data by FIFO module. The single chip microcomputer receives the data, and do FFT for spectrum analysis. The test shows that the simple oscilloscope can realize automatic gain selection, sampling at different sampling rates, high precision frequency measurement and spectrum analysis.
上傳時間： 2022-03-27
上傳用戶：
LED 線陣顯示裝置, 分為 LED 線性旋轉顯示主機和圖文錄入器兩部分。主機用直流電機帶動由紅綠 LED 組成的線陣旋轉, 同時線陣按照時序依次切換顯示狀態, 在固定區域利用視覺暫留效果形成 16×16 點陣, 用以顯示圖文;圖文錄入器用 HMI 觸控屏作為人機交互界面, 實現圖文錄入和回放功能。主機與圖文錄入器通過無線通信方式進行信息交互,可由圖文錄入器控制主機切換不同工作任務, 以及改變線陣顯示內容。The LED linear array display device is divided into two parts:the one is the main unit used to display content,and the other one is used to input the contents.The main unit is driven by a DC motor to rotate the linear array composed by red and green light emitting diodes.At the same time,the 16×16 dot matrix that switching the display state according to the time sequence on the main unit displays pictures and texts in the fixed area,by using the visual temporary effect.The HMI touch screen is used as human machine interface to realize the function that input and playback pictures and texts.The two parts of the device communicate with each other through wireless communication.The image and text input controller can control the main unit to switch different tasks and change the content of linear array displayed.
標簽： stc12c5a60s2 單片機 led
上傳時間： 2022-03-28
上傳用戶：jiabin
因此，您想編寫一個內核模塊。您知道C，您已經編寫了一些可以作為進程運行的常規程序，現在您想知道真正的動作在哪里，一個通配指針可以擦掉文件系統，核心轉儲意味著重新啟動。內核模塊到底是什么？模塊是可以根據需要加載和卸載的代碼段。它們擴展了內核的功能，而無需重新引導系統。例如。模塊驅動程序的一種類型是設備驅動程序，它允許內核訪問沒有模塊的系統硬件，我們將不得不構建單片內核并將新功能直接添加到內核映像中，除了具有更大的內核之外，這還具有缺點每次我們想要新功能時都要求我們重建并重新啟動內核的過程So, you want to write a kernel module. You know C, you, ve written a few normal programs to run as processes, and now you want to get to where the real action is, to where a single wild pointer can wipe out your file system and a core dump means a reboot.What exactly is a kernel module? Modules are pieces of code that can be loaded and unloaded into th upon demand. They extend the functionality of the kernel without the need to reboot the system. For example.one type of module is the device driver, which allows the kernel to access hardware connected to the syste without modules, we would have to build monolithic kernels and add new functionality directly into the em ernel image, Besides having larger kernels
標簽： linux
上傳時間： 2022-03-30
上傳用戶：
