This example program demonstrates how to use the on-chip comparators of the Philips LPC767/768/769 Devices.
標簽： demonstrates comparators the Philips
上傳時間： 2016-02-09
上傳用戶：dyctj
A C++ code for generating sorting networks with n lines and m comparators as input parameters.
標簽： comparators generating parameters networks
上傳時間： 2017-06-14
上傳用戶：ZJX5201314
HT45F43 特性特性特性特性 MCU 特性：內建 2x OPAs & 2x comparators, EEPROM, HIRC 4MHz + 32K LIRC，節省外部器件 傳感器：電化學 Sensor（ME2-CO） 電源電壓：9V 堿性電池 高音量蜂鳴器輸出：（＞85DB） 待機電流：Typ.21uA, Max.27uA 低電壓檢測：7.5V 自測 / 校準功能 LED 顯示：紅、黃、綠三顆 LED 指示 使用 HT45F43 內建 OSC & Reset 電路，節省外部器件 使用 HT45F43 內建 OPA 進行 CO Sensor 信號放大，節 省外部器件 WATCHDOG 每 32 秒喚醒一次進行 CO 濃度偵測和電池電壓偵測
上傳時間： 2013-06-16
上傳用戶：qunquan
Portable, battery-powered operation of electronic apparatushas become increasingly desirable. Medical, remotedata acquisition, power monitoring and other applicationsare good candidates for battery operation. In some circumstances,due to space, power or reliability considerations,it is preferable to operate the circuitry from a single 1.5Vcell. Unfortunately, a 1.5V supply eliminates almost alllinear ICs as design candidates. In fact, the LM10 opamp-reference and the LT®1017/LT1018 comparators arethe only IC gain blocks fully specifi ed for 1.5V operation.Further complications are presented by the 600mV dropof silicon transistors and diodes. This limitation consumesa substantial portion of available supply range, makingcircuit design diffi cult. Additionally, any circuit designedfor 1.5V operation must function at end-of-life batteryvoltage, typically 1.3V. (See Box Section, “Componentsfor 1.5V Operation.”)
標簽： Circuitry Operation Single 1017
上傳時間： 2013-12-20
上傳用戶：Wwill
Portable, battery-powered operation of electronic apparatushas become increasingly desirable. Medical, remotedata acquisition, power monitoring and other applicationsare good candidates for batteryoperation. In some circumstances,due to space, power or reliability considerations,it is preferable to operate the circuitry from a single 1.5Vcell. Unfortunately, a 1.5V supply eliminates almost alllinear ICs as design candidates. In fact, the LM10 opamp-reference and the LT®1017/LT1018 comparators arethe only IC gain blocks fully specifi ed for 1.5V operation.Further complications are presented by the 600mV dropof silicon transistors and diodes. This limitation consumesa substantial portion of available supply range, makingcircuit design diffi cult. Additionally, any circuit designedfor 1.5V operation mustfunction at end-of-life batteryvoltage, typically 1.3V. (See Box Section, “Componentsfor 1.5V Operation.”)
標簽： Circuitry Operation Single Cell
上傳時間： 2013-10-30
上傳用戶：hz07104032
This Application Note covers the basics of how to use Verilog as applied to ComplexProgrammable Logic Devices. Various combinational logic circuit examples, such asmultiplexers, decoders, encoders, comparators and adders are provided. Synchronous logiccircuit examples, such as counters and state machines are also provided.
上傳時間： 2013-11-11
上傳用戶：y13567890
This m file models an UWB system using BPSK. The receiver is a correlation receiver with a LPF integrator and comparators for threshhold selection.
標簽： receiver correlation models system
上傳時間： 2014-12-19
上傳用戶：ryb
