UART to USB Bridge CKT.
上傳時間： 2013-12-22
上傳用戶：yd19890720
This is a PCI to USB bridge schematic that i was draw by hand from a PCI to USB card, the schematic use VT6212L to make bridge, the idear is that we can use microcontroler interface to PC through PCI slot by USB, ha ha it is too easy.
上傳時間： 2017-04-12
上傳用戶：13188549192
Bridge PNE 3.3 source code, running at more than vxworks6.x version.
標簽： running vxworks version Bridge
上傳時間： 2017-05-14
上傳用戶：youke111
control step motor (use for CNC machine), use chip dspic30f4011, include interpolation
標簽： interpolation use control machine
上傳時間： 2017-05-27
上傳用戶：R50974
Wishbone to LPC (Low-Pin Count) Bridge, includes master and slave modules. Supports 8-bit I/O Read and Write cycles, 8-bit Memory Read/Write cycles, DMA cycles, and up to 32-bit Firmware memory read/write cycles. Serial IRQ support is also provided. None of this has been tested (yet) with a third-party LPC Peripheral or Host.
標簽： Wishbone Supports includes Low-Pin
上傳時間： 2014-12-20
上傳用戶：古谷仁美
This is is a bridge IP core to interface the Tensilica PIF bus protocol with the OpenCores WishBone. It currently supports single-cycle as well as burst transfer operations. The core has been tested in a master-PIF slave-WB configuration.
標簽： Tensilica OpenCores interface the
上傳時間： 2013-12-21
上傳用戶：gonuiln
Cypress公司開發的2.4G無線鍵盤鼠標及其Bridge源代碼，對于開發無線鼠標鍵盤的人來說是很好的參考例子！
上傳時間： 2017-07-18
上傳用戶：thuyenvinh
老外用VB寫的CNC仿真程序源碼，可以載入G Code，還有OpenGL的3D圖
上傳時間： 2017-07-22
上傳用戶：愛死愛死
NS-CNC步進電機驅動器.................
上傳時間： 2017-08-06
上傳用戶：jiahao131
userial is an Free project building an USB to I2C/SPI/GPIO bridge, using the Atmel AT90USB647 chip. Hardware and Software are released under an Open Source licence. It supports the following interfaces: * USB interface (serial emulation) * JTAG * I2C (TWI) * SPI * 8 General purpose digital I/O * 4 Analog to Digital converters (currently no firmware support)
標簽： USB building userial project
上傳時間： 2013-12-25
上傳用戶：小鵬
