Given an positive integer A (1 <= A <= 109), output the lowest bit of A. For example, given A = 26, we can write A in binary form as 11010, so the lowest bit of A is 10, so the output should be 2. Another example goes like this: given A = 88, we can write A in binary form as 1011000, so the lowest bit of A is 1000, so the output should be 8.
標簽： A. positive integer example
上傳時間： 2014-01-22
上傳用戶：rocketrevenge
48 bit CRC routines These routines can be used to calculate a 48 bit CRC over an array of characters.
標簽： routines bit CRC calculate
上傳時間： 2014-11-22
上傳用戶：270189020
Infra Red Transmit coding for 8 bit address and data
標簽： Transmit address coding Infra
上傳時間： 2015-11-09
上傳用戶：it男一枚
Infra Red Received coding for received 8 bit address and data code
標簽： Received received address coding
上傳時間： 2014-01-10
上傳用戶：lo25643
bit operation for 64.
標簽： operation bit for 64
上傳時間： 2013-12-17
上傳用戶：jhksyghr
flash serial input queue. returns 0 on success or negative error * number otherwise
標簽： otherwise negative returns success
上傳時間： 2015-11-13
上傳用戶：yxgi5
VHDL實現 8051 CPU核 Oregano Systems 8-bit Microcontroller IP-Core
標簽： Microcontroller Oregano IP-Core Systems
上傳時間： 2013-12-22
上傳用戶：1159797854
k9f2808 16M x 8 Bit , 8M x 16 Bit NAND Flash Memory
標簽： Bit k9f2808 Memory Flash
上傳時間： 2015-11-19
上傳用戶：gaome
LDPC碼譯碼相關文獻 Bounds on the maximum likelihood decoding error probability of low density parity check codes
標簽： probability likelihood decoding maximum
上傳時間： 2015-11-25
上傳用戶：wendy15
This leon3 design is tailored to the Altera NiosII Startix2 Development board, with 16-bit DDR SDRAM and 2 Mbyte of SSRAM. As of this time, the DDR interface only works up to 120 MHz. At 130, DDR data can be read but not written. NOTE: the test bench cannot be simulated with DDR enabled because the Altera pads do not have the correct delay models. * How to program the flash prom with a FPGA programming file 1. Create a hex file of the programming file with Quartus. 2. Convert it to srecord and adjust the load address: objcopy --adjust-vma=0x800000 output_file.hexout -O srec fpga.srec 3. Program the flash memory using grmon: flash erase 0x800000 0xb00000 flash load fpga.srec
標簽： Development Startix2 tailored Altera
上傳時間： 2014-01-19
上傳用戶：chongcongying
蟲蟲下載站版權所有 京ICP備2021023401號-1
