<input id="okwks"></input> The MAX3243E device consists of three line drivers, five line receivers, and a dual charge-pump circuit with±15-kV ESD (HBM and IEC61000-4-2, Air-Gap Discharge) and ±8-kV ESD (IEC61000-4-2, Contact Discharge)protection on serial-port connection pins. The device meets the requirements of TIA/EIA-232-F and provides theelectrical interface between an asynchronous communication controller and the serial-port connector. Thiscombination of drivers and receivers matches that needed for the typical serial port used in an IBM PC/AT, orcompatible. The charge pump and four small external capacitors allow operation from a single 3-V to 5.5-Vsupply. In addition, the device includes an always-active noninverting output (ROUT2B), which allowsapplications using the ring indicator to transmit data while the device is powered down. The device operates atdata signaling rates up to 250 kbit/s and a maximum of 30-V/ms driver output slew rate.
標簽： MULTICHANNEL 5.5 TO RS
上傳時間： 2013-10-19
上傳用戶：ddddddd
The μPSD32xx family, from ST, consists of Flash programmable system devices with a 8032 MicrocontrollerCore. Of these, the μPSD3234A and μPSD3254A are notable for having a complete implementationof the USB hardware directly on the chip, complying with the Universal Serial Bus Specification, Revision1.1.This application note describes a demonstration program that has been written for the DK3200 hardwaredemonstration kit (incorporating a μPSD3234A device). It gives the user an idea of how simple it is to workwith the device, using the HID class as a ready-made device driver for the USB connection.IN-APPLICATION-PROGRAMMING (IAP) AND IN-SYSTEM-PROGRAMMING (ISP)Since the μPSD contains two independent Flash memory arrays, the Micro Controller Unit (MCU) can executecode from one memory while erasing and programming the other. Product firmware updates in thefield can be reliably performed over any communication channel (such as CAN, Ethernet, UART, J1850)using this unique architecture. For In-Application-Programming (IAP), all code is updated through theMCU. The main advantage for the user is that the firmware can be updated remotely. The target applicationruns and takes care on its own program code and data memory.IAP is not the only method to program the firmware in μPSD devices. They can also be programmed usingIn-System-Programming (ISP). A IEEE1149.1-compliant JTAG interface is included on the μPSD. Withthis, the entire device can be rapidly programmed while soldered to the circuit board (Main Flash memory,Secondary Boot Flash memory, the PLD, and all configuration areas). This requires no MCU participation.The MCU is completely bypassed. So, the μPSD can be programmed or reprogrammed any time, anywhere, even when completely uncommitted.Both methods take place with the device in its normal hardware environment, soldered to a printed circuitboard. The IAP method cannot be used without previous use of ISP, because IAP utilizes a small amountof resident code to receive the service commands, and to perform the desired operations.
標簽： Demonstration 3200 USB for
上傳時間： 2014-02-27
上傳用戶：zhangzhenyu
The μPSD32xx family, from ST, consists of Flash programmable system devices with a 8032 Microcontroller Core. Of these, the μPSD3234A and μPSD3254A are notable for having a complete implementation of the USB hardware directly on the chip, complying with the Universal Serial Bus Specification, Revision 1.1.This application note describes a demonstration program that has been written for the DK3200 hardware demonstration kit (incorporating a μPSD3234A device). It gives the user an idea of how simple it is to work with the device, using the HID class as a ready-made device driver for the USB connection.
上傳時間： 2014-04-03
上傳用戶：lizhizheng88
USB接口控制器參考設計,xilinx提供VHDL代碼 usb xilinx vhdl ; This program is free software; you can redistribute it and/or modify ; it under the terms of the GNU General Public License as published by ; the Free Software Foundation; either version 2 of the License, or ; (at your option) any later version. ; ; This program is distributed in the hope that it will be useful, ; but WITHOUT ANY WARRANTY; without even the implied warranty of ; MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. See the ; GNU General Public License for more details. ; ; You should have received a copy of the GNU General Public License ; along with this program; if not, write to the Free Software ; Foundation, Inc., 675 Mass Ave, Cambridge, MA 02139, USA.
上傳時間： 2013-10-12
上傳用戶：windgate
USB接口控制器參考設計,xilinx提供VHDL代碼 usb xilinx vhdl ; This program is free software; you can redistribute it and/or modify ; it under the terms of the GNU General Public License as published by ; the Free Software Foundation; either version 2 of the License, or ; (at your option) any later version. ; ; This program is distributed in the hope that it will be useful, ; but WITHOUT ANY WARRANTY; without even the implied warranty of ; MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. See the ; GNU General Public License for more details. ; ; You should have received a copy of the GNU General Public License ; along with this program; if not, write to the Free Software ; Foundation, Inc., 675 Mass Ave, Cambridge, MA 02139, USA.
上傳時間： 2013-10-29
上傳用戶：zhouchang199
微電腦型RS-485顯示電表（24*48mm/48*96mm） 特點： 5位數RS-485顯示電表 顯示范圍-19999-99999位數 通訊協議Modbus RTU模式 寬范圍交直流兩用電源設計 尺寸小,穩定性高 主要規格： 顯示范圍:-19999~99999 digit RS-485傳輸速度: 19200/9600/4800/2400 selective RS-485通訊位址: "01"-"FF" RS-485通訊協議: Modbus RTU mode 顯示幕: Red high efficiency LEDs high 10.16 mm (0.4") (MMX-RS-11X) Red high efficiency LEDs high 20.32 mm (0.8") (MMX-RS-12X) Red high efficiency LEDs high 10.16 mm (0.4")x2 (MMX-RS-22X) 參數設定方式: Touch switches 記憶方式: Non-volatile E²PROM memory 絕緣耐壓能力: 2KVac/1 min. (input/power) 使用環境條件: 0-50℃(20 to 90% RH non-condensed) 存放環境條件: 0-70℃(20 to 90% RH non-condensed) CE認證: EN 55022:1998/A1:2000 Class A EN 61000-3-2:2000 EN 61000-3-3:1995/A1:2001 EN 55024:1998/A1:2001
上傳時間： 2015-01-03
上傳用戶：feitian920
利用EZ-USB接口芯片AN2131Q實現了基于TMS320C5409的水聲信號采集及混沌特性研究系統中的高速數據通信，提出了一種采用FIFO緩存芯片實現AN2131Q與TMS320C5409的連接方法，深入研究了EZ-USB序列接口芯片的固件、設備驅動和用戶程序開發過程。關鍵詞：AN2131Q; TMS320C5409; IDT72V02；數據通信ABSTRACT: Using AN2131Q as the control chip, the communication between DSP and PC in the underwater acoustic signal acquisition and chaotic characteristics study system is realized. The method is proposed that using FIFO to realize the connectivity between AN2131Q and TMS320C5409. The development of programming Firmware、device driver and user application are thoroughly researched.Key words: AN2131Q; TMS320C5409; IDT72V02; data communication
上傳時間： 2014-04-03
上傳用戶：hahayou
USB Manager(usbmgr) 0.4.8 Shuu Yamaguchi <shuu@wondernetworkresources.com> Special Helper: Philipp Thomas When USB devices connect to or disconnect from a USB hub, the usbmgr works as the following according to configuration. a) It loads and unloads files Linux kernel modules. b) It execute file to setup USB devices.
標簽： wondernetworkresources Yamaguchi Manager Special
上傳時間： 2014-01-27
上傳用戶：zhaiyanzhong
This driver was developed using a USB keyboard from Cherry,as indicated by the VID and PID codes. These IDs must be set for the device you intend to support. Similarly, you will need to set Class to the appropriate string for your device class.
標簽： developed indicated keyboard Cherry
上傳時間： 2015-04-02
上傳用戶：nanxia
LPC2148 USB Audio Device Example This USB example project implements an USB Audio Device that connects via the USB interface to the PC. It may be used on the following devices: LPC2141 LPC2142 LPC2144 LPC2146 LPC2148 An USB Audio Device (HID) does not require any special USB driver, since the USB Audio support is already built into Windows 2000 and Windows XP. Therefore USB Audio devices can be directly connected to the computer. This example project is designed to work with Keil MCB2140 Evaluation Board. Refer to Running USBAudio for information on how to operate this example project.
標簽： Device USB Audio implements
上傳時間： 2015-04-16
上傳用戶：VRMMO
