thinking in c++ new edition for your reference(part two)
標簽： reference thinking edition part
上傳時間： 2014-01-26
上傳用戶：gyq
Express DSP compliant C55x DTMF detector software is proposed in two versions: one with a 5 ms frame size and one with a 10 ms frame size. The versions are quite similar in behavior. The version with a 10 ms frame size is faster, but the overall quality is higher in the 5 ms version, due to lower time granularity. DTMF算法for TI DSP 54X/55X
標簽： compliant detector software proposed
上傳時間： 2016-02-15
上傳用戶：liuchee
Determining embedding dimension for phase-space reconstruction using a geometrical construction. It is very important reference for time forecast in chaos sequence.
標簽： reconstruction construction Determining phase-space
上傳時間： 2013-12-23
上傳用戶：weiwolkt
Linux Server Hacks, Volume Two By Brian K. Jones, William von Hagen ............................................... Publisher: O Reilly Pub Date: December 2005 Print ISBN-10: 0-596-10082-5 Print ISBN-13: 978-0-59-610082-7 Pages: 478
上傳時間： 2016-02-26
上傳用戶：ZJX5201314
this package contains two .c files.One file implements the merge of two int arrays.The other one implements the merge of two linkage array.
標簽：
上傳時間： 2016-02-26
上傳用戶：曹云鵬
The preferred technique places the new YAMON in the opposite Flash bank (the Db1200 boards have two Flash banks), and then changes switch S11 to swap the Flash banks in the memory map to allow the other Flash bank to become the boot bank. This technique is the safest and preferred method since it preserves the existing YAMON
標簽： the preferred technique opposite
上傳時間： 2016-02-27
上傳用戶：thuyenvinh
We shall revisit the limitations of the two-layer networks of the previous one.
標簽： the limitations two-layer networks
上傳時間： 2016-02-27
上傳用戶：shus521
基于OFDM的無線寬帶系統仿真It contains mainly two parts, i.e. link-level simulator and system-level simulator. Link-level simulator focus on a single-cell single-user scenario, where signal is transmitted from tx, and estimated at rx. Comparing the difference in tx/rx signal, the error rate can be found out. The output of the link-level simulator is the BLER/BER vs. SNR mapping table, that can be used for the system-level simulation. System-level simulator focus on a multi-cell multi-user scenario. For the sake of simplicity, it takes the mapping table aquired in the link-level simulation, measure the actural SNR, and finds the corresponding error rate.
標簽： simulator i.e. system-level link-level
上傳時間： 2016-03-15
上傳用戶：xsnjzljj
This project aim was to build wireless software modem for data communication between two computers using an acoustic interface in the voice frequency range (20Hz– 20,000Hz). The transmitting antenna is a speaker (frequency response of: 90Hz – 20,000Hz) and the receiving antenna is a microphone (frequency response of: 100Hz – 16,000Hz). The test files used as information files were text files. This goal was attained both in an incoherent scheme and in a coherent scheme. Build under Matlab code, our modem uses OFDM (orthogonal frequency division multiplexing) modulation, synchronization by LMS sequence, channel estimation (no equalizer) via pilot tones. The symbols are either PSK or ASK for a constellation size of 2 or 4. To optimize the probability of error, these symbols were mapped using Gray mapping. Report
標簽： communication computers software wireless
上傳時間： 2014-05-29
上傳用戶：wangdean1101
ML Estimation of frequency, phase, and amplitude of a sinusoid from discrete time samples MLEsim.m
標簽： Estimation frequency amplitude discrete
上傳時間： 2014-12-07
上傳用戶：dianxin61
