亚洲欧美第一页_禁久久精品乱码_粉嫩av一区二区三区免费野_久草精品视频

蟲蟲首頁| 資源下載| 資源專輯| 精品軟件
登錄| 注冊

Supply

  • XR2981

    2.7V to 5.5V input voltage Range? Efficiency up to 96% ? 24V Boost converter with 12A switch current Limit? 600KHz fixed Switching Frequency? Integrated soft-start? Thermal Shutdown? Under voltage Lockout? Support external LDO auxiliary power Supply? 8-Pin SOP-PP PackageAPPLICATIONSPortable Audio Amplifier Power SupplyPower BankQC 2.0/Type CWireless ChargerPOS Printer Power SupplySmall Motor Power Supply

    標簽: XR2981

    上傳時間: 2021-11-05

    上傳用戶:

  • TI雙軌電源設計

    使用主流buck降壓芯片設計雙軌電源Creating a Split-Rail Power Supply With a Wide Input Voltage Buck Regulator

    標簽: 電源

    上傳時間: 2021-11-07

    上傳用戶:20125101110

  • 開關電源技術講座(英文PDF 30) by national semi.pdf

    Switching Power SupplyFundamentals for theSystem Designer

    標簽: 開關電源

    上傳時間: 2021-11-22

    上傳用戶:

  • 50W隔離型離線式DC.pdf

    ABSTRACTThe flyback power stage is a popular choice for single and multiple output dc-to-dc converters at powerlevels of 150 Watts or less. Without the output inductor required in buck derived topologies, such as theforward or push-pull converter, the component count and cost are reduced. This application note will reviewthe design procedure for the power stage and control electronics of a flyback converter. In these isolatedconverters, the error signal from the secondary still needs to cross the isolation boundary to achieveregulation. By using the UC3965 Precision Reference with Low Offset Error Amplifier on the secondaryside to drive an optocoupler and the UCC3809 Economy Primary Side Controller on the primary side, asimple and low cost 50 Watt isolated power Supply is realized.

    標簽: 隔離

    上傳時間: 2021-11-24

    上傳用戶:kingwide

  • PC1099N datasheet

    The PC1099N from Pixelplus is a CMOS Image Sensor with Mega Pixels 0.3 MP, VGA, Supply Voltage Analog: 3.3 V, HVDD: 3.3 V, CVDD: 3.3 V, Frame Rate 50 to 60 fps, Dynamic Range 63.2 dB, SNR 45.3 dB. More details for PC1099N can be seen below.

    標簽: pc1099n

    上傳時間: 2021-12-12

    上傳用戶:qingfengchizhu

  • 高通(Qualcomm)藍牙芯片QCC5151_硬件設計詳細指導書(官方內部培訓手冊)

    高通(Qualcomm)藍牙芯片QCC5151_硬件設計詳細指導書(官方內部培訓手冊)共52頁其內容是針對硬件設計、部分重要元器件選擇(ESD,Filter)及走線注意事項的詳細說明。2 Power management 2.1 SMPS 2.1.1 Components specification 2.1.2 Input power Supply selection 2.1.3 Minimize SMPS EMI emissions 2.1.4 Internal LDOs and digital core decoupling 2.1.5 Powering external components 2.2 Charger 2.2.1 Charger connections.2.2.2 General charger operation2.2.3 Temperature measurement during charging 2.3 SYS_CTRL 3 Bluetooth radio3.1 RF PSU component choice 3.2 RF band-pass filter3.3 Layout (天線 走線的注意事項)4 Audio4.1 Audio bypass capacitors 4.2 Earphone speaker output4.3 Line/Mic input 4.4 Headphone output optimizition5 LED pads 5.1 LED driver 5.2 Digital/Button input 5.3 Analog input5.4 Disabled 6 Reset pin (Reset#)7 QSPIinterface 8 USB interfaces 8.1 USB device port8.1.1 USB connections8.1.2 Layout notes8.1.3 USB charger detection

    標簽: qualcomm 藍牙芯片 qcc5151

    上傳時間: 2022-01-24

    上傳用戶:XuVshu

  • AD8605/AD8606/AD8608 運算放大器DataSheet

    Precision, Low Noise, CMOS, Rail-to-Rail, Input/Output Operational Amplifiers Data Sheet AD8605/AD8606/AD8608The AD8605, AD8606, and AD86081 are single, dual, and quad rail-to-rail input and output, single-Supply amplifiers. They feature very low offset voltage, low input voltage and current noise, and wide signal bandwidth. They use the Analog Devices, Inc. patented DigiTrim? trimming technique, which achieves

    標簽: 運算放大器

    上傳時間: 2022-02-02

    上傳用戶:

  • STM32L053C8T6數據手冊

    STM32L053C8T6數據手冊Features ? Ultra-low-power platform – 1.65 V to 3.6 V power Supply – -40 to 125 °C temperature range – 0.27 μA Standby mode (2 wakeup pins) – 0.4 μA Stop mode (16 wakeup lines) – 0.8 μA Stop mode + RTC + 8 KB RAM retention – 139 μA/MHz Run mode at 32 MHz – 3.5 μs wakeup time (from RAM) – 5 μs wakeup time (from Flash) ? Core: ARM? 32-bit Cortex?-M0+ with MPU – From 32 kHz up to 32 MHz max.  – 0.95 DMIPS/MHz ? Reset and Supply management – Ultra-safe, low-power BOR (brownout reset)  with 5 selectable thresholds – Ultralow power POR/PDR – Programmable voltage detector (PVD) ? Clock sources – 1 to 25 MHz crystal oscillator – 32 kHz oscillator for RTC with calibration – High speed internal 16 MHz factory-trimmed RC  (+/- 1%) – Internal low-power 37 kHz RC – Internal multispeed low-power 65 kHz to  4.2 MHz RC – PLL for CPU clock ? Pre-programmed bootloader – USART, SPI supported ? Development support – Serial wire debug supported ? Up to 51 fast I/Os (45 I/Os 5V tolerant) ? Memories – Up to 64 KB Flash with ECC – 8KB RAM – 2 KB of data EEPROM with ECC – 20-byte backup register

    標簽: stm32l053c8t6

    上傳時間: 2022-02-06

    上傳用戶:

  • PW4055_2.0.pdf規格書下載

    The PW4055 is a complete constant-current /constant-voltage linear charger for single cell lithiumion batteries.Its ThinSOT package and low external component count make the PW4055 ideallysuited for portable applications.Furthermore, the PW4055 is specifically designed to work within USBpower specifications.The PW4055 No external sense resistor is needed, and no blocking diode is required due to theinternal MOSFET architecture.Thermal feedback regulates the charge current to limit the dietemperature during high power operation or high ambient temperature. The charge voltage is fixedat 4.2V, and the charge current can be programmed externally with a single resistor. The PW4055automatically terminates the charge cycle when the charge current drops to 1/10th the programmedvalue after the final float voltage is reached. When the input Supply (wall adapter or USB Supply) isremoved, the PW4055 automatically enters a low current state, dropping the battery drain currentto less than 2μA. The PW4055 can be put into shutdown mode, reducing the Supply current to 25μA.The BAT pin has a 7KV ESD(HBM) capability. Other features include charge current monitor, undervoltage lockout, automatic recharge and a status pin to indicate charge termination and the presenceof an input voltage

    標簽: pw4055

    上傳時間: 2022-02-11

    上傳用戶:jason_vip1

  • PW2606B.pdf規格書下載

    The PW2606B is a front-end over voltage and over current protection device. It achieves wide inputvoltage range from 2.5VDC to 40VDC. The over voltage threshold can be programmed externally orset to internal default setting. The low resistance of integrated power path nFET switch ensures betterperformance for battery charging system applications. It can deliver up to 1A current to satisfy thebattery Supply system. It integrates the over-temperature protection shutdown and auto-recoverycircuit with hysteresis to protect against over current events

    標簽: pw2606b

    上傳時間: 2022-02-11

    上傳用戶:

主站蜘蛛池模板: 错那县| 肃南| 临桂县| 红河县| 红安县| 宁波市| 云浮市| 方山县| 沂源县| 平南县| 重庆市| 油尖旺区| 通城县| 平安县| 开平市| 尤溪县| 志丹县| 太康县| 威宁| 中阳县| 神池县| 大厂| 夏津县| 普格县| 罗平县| 崇礼县| 合水县| 潞西市| 竹北市| 岢岚县| 永福县| 高青县| 综艺| 军事| 静安区| 米泉市| 台中市| 建瓯市| 嘉兴市| 泽州县| 珠海市|