嵌入式文件系統ucfs.zip
This project should serve as an "easy start" with /FS.
All paths are relative to the project file. You should
therefore be able to copy the entire directory (including
all subdirectories) to any location on your harddrive.
This project is created using the Keil ARM CA Compiler.
The Logic Analyzer built into the simulator may be used to monitor and display any variable or peripheral I/O register. It is already configured to show the PWM output signal on PORT3.0 and PORT3.1
This ARM Example may be debugged using only the uVision Simulator and your PC--no additional hardware or evaluation boards are required. The Simulator provides cycle-accurate simulation of all on-chip peripherals of the ADuC7000 device series.
You may create various input signals like digital pulses, sine waves, sawtooth waves, and square waves using signal functions which you write in C. Signal functions run in the background in the simulator within timing constraints you configure. In this example, several signal functions are defined in the included Startup_SIM.INI file.
The project KEIL_IODemo shows how to use memory allocation routines (malloc) and char I/O (printf, scanf) via a serial interface with the Keil ARM toolchain.
The I/O functions are adapted for the Analog Devices ADuC7000 series using the SERIAL.C module.
The example also shows the efficiency of the Keil CA ARM Compiler run-time library which is tuned for single chip systems.
UART I/O and Memory Allocation Example for GNU
The project GNU_IODemo shows how to use memory allocation routines (malloc) and char I/O (printf, scanf) via a serial interface with the GNU toolchain.
The I/O functions are adapted for the Analog Devices ADuC7000 series using the SERIAL.C module.
The example also shows the efficiency of the Keil CA ARM Compiler run-time library which is tuned for single chip systems.
