|Introduction Basic Concept Tips to layout Power circuit Type of Power circuit
Basic Concept Maximum CURRENT calculation Resistance of Copper ideal power supply & noise Capacitor & Inductor Power consumption Function of power circuit
超導限流器作為非線性元件短路電流限制器,具有體積小、重量輕、損耗小的特點。飽和鐵心型超導限流器(Saturated Iron Core Superconductive Fault CURRENT Limiter--SICSFCL)作為超導限流器中具有技術優勢,可適用于高壓電網的限流器必將得到廣泛應用,本文通過對SICSFCL工作原理分析,運用Ansoft軟件搭建220 kV/800A型號的SICSFCL,分析其不同外部短路電流下工作特性。表明SICSFCL對于220 kV電網短路電流具有良好的限制作用,可滿足電網中電氣設備的安全可靠運行要求。
為了提高直接轉矩控制(DTC)系統定子磁鏈估計精度,降低電流、電壓測量的隨機誤差,提出了一種基于擴展卡爾曼濾波(EKF)實現異步電機轉子位置和速度估計的方法。擴展卡爾曼濾波器是建立在基于旋轉坐標系下由定子電流、電壓、轉子轉速和其它電機參量所構成的電機模型上,將定子電流、定子磁鏈、轉速和轉子角位置作為狀態變量,定子電壓為輸入變量,定子電流為輸出變量,通過對磁鏈和轉速的閉環控制提高定子磁鏈的估計精度,實現了異步電機的無速度傳感器直接轉矩控制策略,仿真結果驗證了該方法的可行性,提高了直接轉矩的控制性能。
Abstract:
In order to improve the Direct Torque Control(DTC) system of stator flux estimation accuracy and reduce the CURRENT, voltage measurement of random error, a novel method to estimate the speed and rotor position of asynchronous motor based on extended Kalman filter was introduced. EKF was based on d-p axis motor and other motor parameters (state vector: stator CURRENT, stator flux linkage, rotor angular speed and position; input: stator voltage; output: staror CURRENT). EKF was designed for stator flux and rotor speed estimation in close-loop control. It can improve the estimated accuracy of stator flux. It is possible to estimate the speed and rotor position and implement asynchronous motor drives without position and speed sensors. The simulation results show it is efficient and improves the control performance.
Abstract: This application note discusses the REF pin functionality in the indirect CURRENT-feedbackarchitecture for instrumentation amplifiers. This article compares the importance of a REF buffer in a
yright 2002 Cygnal Integrated Products, Inc. // // Filename: LIION_BC_MAIN.c // Target Device: 8051F300 // Created: 11 SEP 2002 // Created By: DKC // Tool chain: KEIL Eval C51 // // This is a stand alone battery charger for a Lithium ION battery. // It utilizes a buck converter, controlled by the on-chip 8-bit PWM, // to provide constant CURRENT followed by constant voltage battery charge.
mp3設計程序資料,采用c語言編寫。
README file for
yampp-3 source code 2001-05-27
This is the CURRENT state of the yampp-3 source code, 2001-05-27.
This code is intended to run on Rev. B of the yampp-3 PCB, but can
ofcourse be used on compatible systems as well.
It still uses the "old" song selection system as the yampp-2.
However, the disk handling routines has improved a lot and the
obviosly, the new VS1001 handling has been put in.
The codesize is almost at it s maximum at 1F40 bytes.
A .ROM file is included if you don t have the compiler set up.
For now, the documentation is in the code
The Point-to-Point Protocol (PPP)
for the
Transmission of Multi-protocol Datagrams
over Point-to-Point Links
Status of this Memo
This RFC specifies an IAB standards track protocol for the Internet
community, and requests discussion and suggestions for improvements.
Please refer to the CURRENT edition of the "IAB Official Protocol
Standards" for the standardization state and status of this protocol.
Distribution of this memo is unlimited.