本書第一部分講述的是傳統的網絡接口N e t B I O S、重定向器以及通過重定向器進行的各類
網絡通信。盡管本書大部分內容均圍繞Wi n s o c k編程這一主題展開，但是， A P I比起Wi n s o c k
來，仍然具有某些獨到之處
采用3D Bresenham算法在兩點間劃一直線
％ This program is ported to MATLAB from:
％ B.Pendleton. line3d - 3D Bresenham s (a 3D line drawing algorithm)
％ ftp://ftp.isc.org/pub/usenet/comp.sources.unix/volume26/line3d, 1992
％
％ Which is referenced by:
％ Fischer, J., A. del Rio (2004). A Fast Method for Applying Rigid
％ Transformations to Volume Data, WSCG2004 Conference.
％ http://wscg.zcu.cz/wscg2004/Papers_2004_Short/M19.pdf
隨著光伏發電系統快速發展,以及電動汽車充電樁的普及,傳統的剩余電流保護器無法滿足實際需求。介紹了一款B型剩余電流保護器,采用磁調制剩余電流互感器和零序電流互感器采集剩余電流。根據GB/T 22794—2017標準要求,可識別1 kHz及以下的正弦交流、帶和不帶直流分量的脈動直流、平滑直流等剩余電流信號。經信號調理電路將電壓信號送到單片機進行采集和判斷。通過試驗測試,該樣機在測試精度和速度上均符合國家標準的相關要求。The rapid development of photovoltaic power generation systems and the popularity of electric vehicle charging piles make the traditional residual current protective devices unable to meet the actual demand.This paper proposed a type B residual current protective device,which uses the magnetically modulated residual current transformer and the zero sequence current transformer to acquire the residual current.According to the requirements of GB/T 22794—2017,the type B residual current protective device can detect sinusoidal AC residual current of 1kHz and below 1kHz,pulsating DC residual current with and without DC component,smooth DC residual current and so on.The signal processing circuit sends the voltage signal to the MCU for acquisition and judgment.Through experimental tests,the device meets the relevant requirements of national standards in terms of test accuracy and speed.
