西門子PLC培訓教程.rar PLC主要是指數字運算操作電子系統的可編程邏輯控制器，用于控制機械的生產過程。也是公共有限公司、電源線車等的名稱縮寫。
上傳時間： 2013-11-03
上傳用戶：sk5201314
This application report discusses the design of non-invasive optical plethysmographyalso called as pulsoximeter using the MSP430FG437 Microcontroller (MCU). Thepulsoximeter consists of a peripheral probe combined with the MCU displaying theoxygen saturation and pulse rate on a LCD glass. The same sensor is used for bothheart-rate detection and pulsoximetering in this application. The probe is placed on aperipheral point of the body such as a finger tip, ear lobe or the nose. The probeincludes two light emitting diodes (LEDs), one in the visible red spectrum (660nm) andthe other in the infrared spectrum (940nm). The percentage of oxygen in the body isworked by measuring the intensity from each frequency of light after it transmitsthrough the body and then calculating the ratio between these two intensities.
標簽： Pulsoximeter Single-Chip Des
上傳時間： 2013-10-27
上傳用戶：黑漆漆
DAC0832是一個8位D/A轉換器芯片，單電源供電，從+5V～+15V均可正常工作，基準電壓的范圍為±10V，電流建立時間為1μs，CMOS工藝，低功耗20mW。其內部結構如圖9.1所示，它由1個8位輸入寄存器、1個8位DAC寄存器和1個8位D/A轉換器組成和引腳排列如圖1所示。 • DAC0832工作方式• ADC0809工作方式要求掌握：• MCS-51單片機與D/A轉換器的接口連接• MCS-51單片機與A/D轉換器的接口連接• 初始化編程及應用了解：• 典型D/A轉換器芯片DAC0832的管腳功能• 典型A/D轉換器芯片ADC0809的管腳功能
標簽： MCS 51 單片機 轉換器
上傳時間： 2014-01-14
上傳用戶：zl520l
ADC0809是帶有8位A/D轉換器、8路多路開關以及微處理機兼容的控制邏輯的CMOS組件。它是逐次逼近式A/D轉換器，可以和單片機直接接口。 adc0809 datasheet
標簽： 0809 ADC 轉換器 應用技術
上傳時間： 2013-10-11
上傳用戶：kz_zank
This application note describes how to decode standard DTMF tones using the minimum number of external discrete components and a PIC. The two examples use a PIC which has an 8 bit timer and either a comparator or an ADC, although it can be modified for use on a PIC which has only digital I/O. The Appendices have example code for the 16C662 (with comparator) and 16F877 (using the ADC). As the majority of the Digital Signal Processing is done in software, little is required in the way of external signal conditioning. Software techniques are used to model the individual elements of a DTMF Decoder IC.
標簽： Decoding DTMF with PIC
上傳時間： 2013-11-21
上傳用戶：zhaoke2005
可編程控制器PLC以抗擾性強、可靠性高和編程靈活等特點在工業上得到廣泛應用，為了優化PLC系統設計，介紹一種基于MCS．51單片機的PLC仿真器，并給出了硬、軟件設計與實現方法。編程設計主要包括監控主程序、與主機通訊子程序及用戶指令解釋子程序等模塊設計，該設計方案簡潔，輸入／輸出接點可擴展，為PLC系統設計及實驗教學提供了理論數據和途徑。
標簽： MCS PLC 51單片機 仿真器
上傳時間： 2013-10-23
上傳用戶：chendawei
plc\cad\模具設計軟件
上傳時間： 2013-10-30
上傳用戶：wangdean1101
介紹用PIC16C73 自帶的八位A/D 轉換器擴展為十二位A/D 轉換器，給出了具體的設計方案和程序流程。它是用以 PIC16C73 為MCU 構成的海水有機磷測控儀A/D 轉換部分的一種解決方案。為監測海洋生態環境，研制了用于海水有機磷農藥現場監測的生物傳感器。為測定生物傳感器的信號，使傳感器可用于船載及臺站的海洋生態環境現場自動監測，需要對整個的采樣和排液裝置進行控制以及對傳感器來的信號進行實時采集處理，形成有機磷的濃度傳給上位機。為此，開發了以PIC16C73 單片機為核心的小型測控儀器，很好的完成了上述功能。PIC1673 單片機自帶8 位的A/D 轉換器，但不能滿足系統對精度的要求，本設計在單片機自帶8 位A/D 基礎上加少量的硬件和軟件開銷，使其擴展為十二位A/D 轉換器，滿足了系統的要求。
上傳時間： 2013-10-30
上傳用戶：a296386173
新穎實用的單片機雙積分A/D轉換電路和軟件:摘 要: 通過對雙積分A/ D 轉換過程及其原理的分析,結合8031 單片機定時計數器的特點,設計出一種新的A/ D 轉換電路. 詳細介紹了這種轉換電路的硬件原理及工作過程,給出了實用的硬件電路與軟件設計框圖. 通過比較分析,可以看出這種A/ D 轉換電路性能價格比較高,軟件編程簡單,并且轉換速度和精度優于一般的A/ D 轉換電路. 這種設計思路為數模轉換器(A/ D) 的升級提高指出一個明確的方向.關鍵詞:單片機; 定時/ 計數器; A/ D 轉換; 雙積分 雙積分A/ D 及定時計數器原理:我們先分析雙積分A/ D 轉換的工作原理. 如圖1 所示,積分器先以固定時間T 對待測的輸入模擬電壓Vi 進行正向積分,積分電容C 積累的電荷為
標簽： 單片機 雙積分 轉換電路 軟件
上傳時間： 2014-01-18
上傳用戶：hewenzhi
The C500 microcontroller family usually provides only one on-chip synchronous serialchannel (SSC). If a second SSC is required, an emulation of the missing interface mayhelp to avoid an external hardware solution with additional electronic components.The solution presented in this paper and in the attached source files emulates the mostimportant SSC functions by using optimized SW routines with a performance up to 25KBaud in Slave Mode with half duplex transmission and an overhead less than 60% atSAB C513 with 12 MHz. Due to the implementation in C this performance is not the limitof the chip. A pure implementation in assembler will result in a strong reduction of theCPU load and therefore increase the maximum speed of the interface. In addition,microcontrollers like the SAB C505 will speed up the interface by a factor of two becauseof an optimized architecture compared with the SAB C513.Moreover, this solution lays stress on using as few on-chip hardware resources aspossible. A more excessive consumption of those resources will result in a highermaximum speed of the emulated interface.Due to the restricted performance of an 8 bit microcontroller a pin compatible solution isprovided only; the internal register based programming interface is replaced by a set ofsubroutine calls.The attached source files also contain a test shell, which demonstrates how to exchangeinformation between an on-chip HW-SSC and the emulated SW-SSC via 5 external wiresin different operation modes. It is based on the SAB C513 (Siemens 8 bit microcontroller).A table with load measurements is presented to give an indication for the fraction of CPUperformance required by software for emulating the SSC.
標簽： synchronous Emulating serial
上傳時間： 2014-01-31
上傳用戶：z1191176801
蟲蟲下載站版權所有 京ICP備2021023401號-1
