亚洲欧美第一页_禁久久精品乱码_粉嫩av一区二区三区免费野_久草精品视频

蟲蟲首頁| 資源下載| 資源專輯| 精品軟件
登錄| 注冊

Device-to-Device

  • 100-15V TO 12V DCDC 原理圖 PCB BOM表

    高的工作電壓高達100V N雙N溝道MOSFET同步驅動 The D810DCDC is a synchronous step-down switching regulator controller that can directly step-down voltages from up to 100V, making it ideal for telecom and automotive applications. The D810DCDC uses a constant on-time valley current control architecture to deliver very low duty cycles with accurate cycle-by-cycle current limit, without requiring a sense resistor. A precise internal reference provides 0.5% DC accuracy. A high bandwidth (25MHz) error amplifi er provides very fast line and load transient response. Large 1Ω gate drivers allow the D810DCDC to drive multiple MOSFETs for higher current applications. The operating frequency is selected by an external resistor and is compensated for variations in VIN and can also be synchronized to an external clock for switching-noise sensitive applications. Integrated bias control generates gate drive power from the input supply during start-up and when an output shortcircuit occurs, with the addition of a small external SOT23 MOSFET. When in regulation, power is derived from the output for higher effi ciency.

    標簽: DCDC 100 12V BOM

    上傳時間: 2013-10-24

    上傳用戶:wd450412225

  • LTM4600 DCDC微型模塊熱性能

      The LTM4600 DC/DC μModule regulator is a complete highpower density stepdown regulator for 10A continuous (14Apeak) loads. The device has two voltage options: 20VINmaximum for the LTM4600EV and 28VIN maximum for theLTM4600HVEV each housed in a small 15mm ¥ 15mm ¥2.8mm LGA surface mount package.

    標簽: 4600 DCDC LTM 微型模塊

    上傳時間: 2013-10-10

    上傳用戶:adada

  • 逆變電路的基本工作原理

    單相橋式逆變電路為例:S1~S4是橋式電路的4個臂,由電力電子器件及輔助電路組成。S1、S4閉合,S2、S3斷開時,負載電壓uo為正S1;S1、S4斷開,S2、S3閉合時,uo為負,把直流電變成了交流電。改變兩組開關切換頻率,可改變輸出交流電頻率。圖5-1 逆變電路及其波形舉例電阻負載時,負載電流io和uo的波形相同,相位也相同。阻感負載時,io滯后于uo,波形也不同(圖5-1b)。t1前:S1、S4通,uo和io均為正。t1時刻斷開S1、S4,合上S2、S3,uo變負,但io不能立刻反向。io從電源負極流出,經S2、負載和S3流回正極,負載電感能量向電源反饋,io逐漸減小,t2時刻降為零,之后io才反向并增大 (2)換流方式分類換流——電流從一個支路向另一個支路轉移的過程,也稱換相。開通:適當的門極驅動信號就可使其開通。關斷:全控型器件可通過門極關斷。半控型器件晶閘管,必須利用外部條件才能關斷,一般在晶閘管電流過零后施加一定時間反壓,才能關斷。研究換流方式主要是研究如何使器件關斷。本章換流及換流方式問題最為全面集中,因此在本章講述1、器件換流利用全控型器件的自關斷能力進行換流(Device Commutation)。2、電網換流由電網提供換流電壓稱為電網換流(Line Commutation)。可控整流電路、交流調壓電路和采用相控方式的交交變頻電路,不需器件具有門極可關斷能力,也不需要為換流附加元件。3、負載換流由負載提供換流電壓稱為負載換流(Load Commutation)。負載電流相位超前于負載電壓的場合,都可實現負載換流。負載為電容性負載時,負載為同步電動機時,可實現負載換流。

    標簽: 逆變電路 基本工作

    上傳時間: 2013-10-15

    上傳用戶:qingdou

  • MSP430F13x14x14x1 Device Erratasheet (Rev. B)

    msp430單片機

    標簽: Erratasheet 14x x14 Device

    上傳時間: 2013-10-19

    上傳用戶:dick_sh

  • USB TO Gigabit LAN網卡的設計與制作

    畢業設計 USB TO Gigabit LAN 網卡 隨著網絡技術飛速發展,多媒體的應用越來越多,人們對網絡的要求也越來越高,為了適應市場的需求,網卡出現了。它以其結構簡單、成本低廉、兼容性強等諸多的優越性得到了廣泛的應用。由于網絡的應用越來越廣泛,網卡的應用也越來越多、功能越來越強大。開始時由于技術方面的限制,網卡只有10Mbps的吞吐量,由于網絡技術的發展,100Mbps吞吐量的網卡開始在市場上得到廣泛的應用。而現在1000Mbps吞吐量的網卡的出現又給網絡的傳輸帶來了新的活力。 論文中主要闡述了基于以太網的USB TO Gigabit LAN網卡的設計與制作。論文首先對以太網進行了介紹,緊接著講了網卡的基本知識。隨后又對USB TO Gigabit LAN網卡的電路設計和制作進行了詳細的描述。論文還包括了USB TO Gigabit LAN網卡的調試等內容。

    標簽: Gigabit USB LAN TO

    上傳時間: 2014-12-02

    上傳用戶:wab1981

  • 基于AVR的新型防汽車追尾安全裝置設計

    針對目前汽車追尾事件頻發問題,提出一種防汽車車前和車后追尾的安全裝置設計。該設計以高性能、低功耗的8位AVR微處理器ATmega8L為核心,結合霍爾式車速傳感器、激光雷達測距裝置和MMA7260QT加速度傳感器,能夠兼顧車前和車后,摒棄以往設計中只考慮車前或車后單一性缺點,尤其適用于高速、夜晚或新手行車。 Abstract:  Aiming at the high frequency of vehicle rear-end collision,a safe device design of anti-vehicle rear-end collision is presented.In the design,the high-performance,low-power8-bit AVR microprocessor ATmega8L is utilized as a core combined with Hall-type speed sensor,laser-radar ranging devices and the acceleration sensor MMA7260QT.The design considers both the front and back of a car,and overcomes the drawbacks of former designs in which only the front or the back of the car is considered,so it is especially suitable for high-speed,night or the beginner’s driving.

    標簽: AVR 汽車追尾 裝置

    上傳時間: 2013-10-14

    上傳用戶:GavinNeko

  • 串行時鐘PCF8583在微機保護裝置中的應用

    實時時鐘是微機保護裝置的重要部件,在討論PCF8583結構與功能的基礎上,提出采用dsPIC33F系列微處理器與串行I2C時鐘PCF8583的接口設計方案,給出了相應的接口電路與軟件流程。該設計方案結構簡單,可靠性高,開發周期短,具有一定的實用與參考價值。所設計的微機保護裝置已投入現場運行,效果良好。 Abstract:  Real-time clock chip is an important part in microcomputer protection device.Based on discussing the structure and function of PCF8583,a new interface scheme which uses dsPIC33F microprocessor and serial clock chip(I2C)PCF8583is proposed.The method of the circuit design and the main software flow are introduced in this paper.The scheme has simple structure,higher reliability and shorter exploitation cycle,so has definite practicality or reference value.The microcomputer protection device has been put into operation with better effects.

    標簽: 8583 PCF 串行時鐘 中的應用

    上傳時間: 2013-11-18

    上傳用戶:Thuan

  • 微處理器dsPIC33F在微機保護裝置中的應用

    數字信號處理器dsPIC33F集多通道高精度A/D轉換、多通訊模式、看門狗、CMOS Flash技術等于一體,其內部可完成所有數據操作,實現總線不出芯片技術。將該處理器應用于微機保護裝置,提出基于dsPIC33F微處理器的微機保護裝置的設計方案,給出相應的接口電路與軟件流程。該設計方案結構簡單,性價比及可靠性高,開發周期短,具有一定的實用推廣價值。所研制的微機保護裝置現場運行效果良好。 Abstract:  The dsPIC33F microprocessor has a plentiful interior resource which contains multi-channel,high precision A/D converters,multi-communication module,watchdog,CMOS Flash technology,and so on.All data manipulations is accomplished interiorly.What is more,it makes the technology that bus does not go beyond the chip comes into practice.The paper put forwards a design scheme based on dsPIC33F microprocessor.The scheme has the advantages of simple structure,high reliability and shortened exploitation cycle.What is more,it has definite practicality and reference.The microcomputer protection device has been put into operation with excellent effects.

    標簽: dsPIC 33F 33 微處理器

    上傳時間: 2013-11-16

    上傳用戶:開懷常笑

  • 基于C8051F340的數據采集器設計

    針對眾多低成本數據采集需求,采用帶有片上USB控制器和D/A轉換器的混合信號微處理器C8051F340,設計了一款可通過USB接口和LabVIEW圖形用戶界面實現與PC機聯機的數據采集器,同時借助系統的SD卡存儲獨立實現現場長時間采集數據。該數據采集器成本低,結構簡單,體積小,已成功用于工業現場。 Abstract:  Aiming at the need of low cost data acquisition, a data acquisition device is designed based on C8051F340 which is a mixed-signal microcontroller and integrates USB controller and A/D controller on a chip.The data acquisition device which can combine with PC by USB interface and LabVIEW graphical user interface,can realize data acquisition. At the same time,it can be solely run a long time in virtue of SD card in field.The date aequisition device features low cost,simple structure and little sharp, and it has been used in industry field.

    標簽: C8051F340 數據 集器設計

    上傳時間: 2014-05-31

    上傳用戶:1109003457

  • CAT93C46 器件數據手冊

    The CAT93C46 is a 1 kb Serial EEPROM memory device which isconfigured as either 64 registers of 16 bits (ORG pin at VCC) or 128registers of 8 bits (ORG pin at GND). Each register can be written (orread) serially by using the DI (or DO) pin. The CAT93C46 features aself−timed internal write with auto−clear. On−chip Power−On Resetcircuit protects the internal logic against powering up in the wrongstate.

    標簽: CAT 93C C46 93

    上傳時間: 2013-11-20

    上傳用戶:ynzfm

主站蜘蛛池模板: 栾川县| 奉节县| 大洼县| 凤山县| 吴桥县| 抚宁县| 烟台市| 云龙县| 新营市| 墨玉县| 集贤县| 海丰县| 柳林县| 麻城市| 水城县| 崇阳县| 神农架林区| 娄底市| 连南| 灵宝市| 博客| 遂平县| 留坝县| 外汇| 垫江县| 玉树县| 仲巴县| 奉化市| 乌兰浩特市| 九龙坡区| 凌云县| 曲松县| 墨竹工卡县| 卓尼县| 含山县| 什邡市| 东至县| 安塞县| 璧山县| 丰县| 沐川县|